Operation - Bosch LR2 Operating/Safety Instructions Manual

Weight
Dimensions
1) The working range can be decreased by unfavourable
2) The angular accuracy between the 45° laser line and
Please observe the article number on the type plate of your tool.
The trade names of the individual tools may vary.
The tool can be clearly identified with the serial number 12 on
the type plate.
Initial Operation
• Protect the tool against moisture.
• Do not subject the tool to extreme temperatures or
variations in temperature.
As an example, do not leave it in vehicles for longer periods. I
in case of large variations in temperature, allow the tool to
adjust to the ambient temperature before putting it into
operation. In case of extreme temperatures or variations in
temperature, the accuracy of the tool canbe impaired.
Setting Up the Tool (see figure A)
Position the tool at least 17ft (5m) away from the cross-line
laser. Switch on the pulsating function on the cross-line laser,
and select horizontal or vertical operation.
Note: Do not select cross-line operation, as otherwise faulty
indications on the height of the laser beam can occur.
Position the tool in such a manner that the laser beam can
reach the reception area 6. Align the tool in such a manner that
the laser beam runs laterally through the reception area (as
shown in the figure).
Switching On and Off
• A loud audio signal sounds when switching on the tool.
Therefore, keep the tool away from your ear or other person
when switching on. The loud audio signal can cause
hearing defects.
To switch on the tool, press the On/Off button 2. All display
indicators as well as all LEDs light up briefly and an audio
signal sounds.
To switch off the tool, press the On/Off button 2 again. Before
switching off, all LEDs briefly light up.
1.800.561.8187
environmental conditions (e.g. direct sun irradiation).
the 90° laser line is max. ±0.4 mm/m.
www.

Operation

-9-
.com
0.44lb (0.2 kg)
5.9" x 2.9" x 1.6"
(150x 74 x 41mm)
information@itm.com