Securing Workpiece; Operation; Cutting Capacity - Makita M2402 Instruction Manual

M2403
► 1. Hex wrench

OPERATION

CAUTION:
Proper handle pressure during
cutting and maximum cutting efficiency can
be determined by the amount of sparks that is
produced while cutting. Do not force the cut
by applying excessive pressure on the handle.
Reduced cutting efficiency, premature wheel wear, as
well as, possible damage to the tool, cut-off wheel or
workpiece may result.
Hold the handle firmly. Switch on the tool and wait until the
cut-off wheel attains full speed before lowering gently into
the cut. When the cut-off wheel contacts the workpiece,
gradually bear down on the handle to perform the cut.
When the cut is completed, switch off the tool and wait
until the cut-off wheel has come to a complete stop
before returning the handle to the fully elevated position.

Cutting capacity

Maximum cutting capacity varies depending on the
cutting angle and workpiece shape.
Max. cutting capacity with a brand-new cut-off wheel
Cutting angle /
Workpiece shape
102 x 194 mm
(4" x 7-5/8")
70 x 233 mm
(2-3/4" x 9-1/8")
119 x 119 mm
(4-11/16" x
137 x 137 x 10 mm
(5-3/8" x 5-3/8"
90° 45°
127 mm 127 mm
(5") (5")
115 x 103 mm
(4-1/2" x 4-1/16")
106 x 106 mm
(4-3/16" x 4-3/16")
4-11/16")
100 x 100 x 10 mm
(4" x 4" x 3/8")
x 3/8")

Securing workpiece

CAUTION:
1
the shaft threads when securing the workpiece.
Failure to do so may result in insufficient securing of
the workpiece. This could cause the workpiece to be
ejected or cause a dangerous breakage of the cut-off
wheel.
While the thread holder is lifted, the vise plate can be
moved in and out quickly. To grip a workpiece, push the
handle until the vise plate contacts the workpiece then
return the thread holder. Turn the handle clockwise until
the workpiece is securely retained.
1
► 1. Handle 2. Thread holder 3. Vise plate
When the cut-off wheel has worn down considerably,
place a spacer block behind the workpiece as shown
in the figure. You can more efficiently utilize the worn
wheel by using the mid point on the periphery of the
wheel to cut the workpiece. Use a sturdy and non-flam-
mable material for a spacer block.
► 1. Spacer block
When cutting workpieces over 85 mm (3-3/8") wide at
an angle, attach a straight piece of wood (spacer) over
190 mm (7-1/2") long x 45 mm (1-3/4") wide to the guide
plate as shown in the figure. Attach this spacer with
screws through the holes in the guide plate. Make sure
that the cut-off wheel does not contact the spacer when
the tool head is depressed.
10 ENGLISH
Always place the thread holder on
2 3
1