Setting The Temperature; Dry Ironing; Refilling The Water Tank - TEFAL EXPRESS POWER ZONE Manual

Anti-calc autoclean

Hide thumbs

Table Of Contents

Table of Contents

Available languages

1800121673 GV74XX 7lgues_110x154 17/03/11 15:17 Page11

SETTING THE TEMPERATURE AND STEAM OUTPUT ACCORDING TO TYPE OF FABRIC TO BE IRONED:

YPE OF FABRICS

Silk, Synthetics

(polyester, acetate, acrylic, polyamide)

Silk, Wool

Linen, cotton

To prime the steam circuit, either

before using the iron for the first

time, or if you have not used the

steam function for a few

minutes, press the steam control

button several times in a row,

holding the iron away from your

- fig.6

clothes

. This will enable

any cold water to be ejected

from the steam circuit.

MODE ECO:

Your steam generator iron has an ECO mode function which uses less power whilst still guaranteeing a sufficient steam flow for you to

iron your garments properly. In order to use this function, once the thermostat of your iron has been correctly set (see table above),

position the steam flow setting on the ECO segment

or very creased fabrics, we recommend that you use the maximum steam flow for best results.

Dry ironing

• Do not press the steam control button under the iron handle.

Recommendations: for

fabrics other than linen or

cotton, hold the iron a few

centimetres from the

garment to avoid burning

the fabric.

Refilling the water tank

• When the "tank empty" red warning light flashes

• Unplug the steam generator. Open the tank filler flap

Fill the water tank up without exceeding the MAX level

• Close the water tank filler cover.

• Plug in the steam generator. Press the "OK" button

remains lit, the steam is ready.

• Your appliance includes the Power Zone function: concentrated steam shot at the tip of the soleplate, to be used in particular

to target stubborn creases, detailing and zones that are difficult to access.

• To use this function, press the Power Zone function on top of the iron as often as necessary

Catalysis Autoclean Soleplate

• The iron of your steam generator comes with a self-cleaning soleplate which functions by catalysis.

• Its unique coating makes it possible to continually eliminate all the impurities arising from normal usage.

• We recommend you always place your iron on its base or on the iron rest plate in order to protect its self-cleaning

coating.

SETTING TEMPERATURE

CONTROL

•

••

•••

• Iron temperature setting

- Start with the fabrics to be ironed at a low temperature (•) and finish with those which need

higher temperatures (••• or Max).

- Mixed fibre fabric: set the ironing temperature to the setting for the most delicate fabric.

- Woollen garments: press repeatedly on the steam control button

of steam, without placing the iron on the garment itself.

• Steam output setting:

- Thick fabric: increase the steam setting.

- At a low temperature : set the steam output control dial to the low position.

fig.12. The ECO mode can be used on all types of fabrics, however, for very thick

• Set the iron temperature control slide and the steam output control dial (located on the control

panel) to the MAX position.

• Hang the garment on a coat hanger and hold the fabric slightly taut with one hand.

As steam is very hot: never attempt to remove creases from a garment while it is being

worn, always hang garments on a coat hanger.

• Holding the iron in a vertical position

steam control button (underneath the iron handle) moving the iron from top to bottom

- fig.10,

it means that you have no more steam. The water tank is empty.

fig.4.

fig.11, on the control panel to continue ironing. When the green indicator

Power Zone Function (according to model)