Advertisement
Description
1.
Steam control button
2.
Iron temperature control dial
3.
Iron thermostat light
4.
Iron rest
5.
Control panel
a) ECO mode button
b) on/off button
c) anti-calc button
Locking system
Your appliance is fitted with a retaining hoop to hold the iron onto the base with a locked position for easy
transport and storage:
Preparation
What water may be used ?
This appliance has been designed to be used with untreated tap water.
Types of water not to use: In order to help extend the life of your appliance, you should not use water from clothes
dryers, scented or softened water containing additives, water from refrigerators, batteries, air conditioners, rain
water, boiled, filtered or bottled water. Do not use pure distilled nor pure demineralised water.
All the type of water listed above may contain organic waste, mineral or chemical elements that can cause spitting,
brown staining or premature wear of the appliance. If your water is very hard, we recommend you use a mix of
50% untreated tap water and 50% distilled water available in hardware stores.
Do not fill the water tank from the cartridge compartment.
Filling the water tank
• Remove the detachable water tank using the handle (located at the front of the steam generator)
• Fill the water tank without exceeding the Max level
• Push it back into its housing until you hear a «click»
Using your appliance
The first time the appliance is used, there may be some fumes and smell but this is not harmful. They will not affect use
and will disappear rapidly.
• Ensure you place the appliance on a flat, stable, heat and water resistant surface.
• Completely unwind the power cord and the water connection cord.
• Always ensure that the base unit is positioned close enough to the ironing surface to avoid straining and
premature wear of the water connection cord.
• Plug in your appliance to an earthed socket.
• Press on the on / off switch. The on/off indicator located on the control panel flashes while the iron heats up.
When the on/off indicator light stops flashing (after 2 minutes approximately), the appliance is ready for use.
• If you use the appliance for the first time, if you have replaced the anti calc cartridge or after filling the
water tank, press the steam control button continuously for a few minutes pointing it away from your linen,
in order to prime the pump and obtain steam when the temperature dial is in the max position.
• When in use, electric pump injects water into the iron solepate. It makes a noise but this is normal.
Use
Setting the temperature
Do not place the iron on a metal support.When taking a break from ironing, always place the iron on the
iron rest plate of the unit. It is equipped with non-slip pads and has been designed to withstand high
temperatures.
• Adjust the iron's temperature control dial according to the type of fabric to be ironed (see table below).
• The iron thermostat light will flash each time you change the position. it will be fixed once the temperature is
ready.
• Steam may take some time to start as your appliance needs to activate its water circuit.
• The steam will stop when you release the button.
• Always spray starch onto the reverse side of the fabric to be ironed.
(depending on model)
6.
Water connection cord storage
7.
Anti-calc cartridge
8.
Soleplate
9.
Removable water tank
10.
Lock system (depending on model)
17
Advertisement
