Typical Unit Repair Parts List - Quincy Air Master QT Series Parts Manual

TYPICAL UNIT REPAIR PARTS LIST

The parts listed here are for standard QT-7.5 (up to 175 p.s.i.) units and may or may not be applicable to custom built units. Check with
your local authorized AirMaster Distributor for parts that can be used for custom built units. Make sure the components you order are rated
within the safe operating limits of your system. If you are doubtful about which components to order, contact your local AirMaster
Distributor.
(QT-7.5 simplex - horizontal tank - electric motor)
Part
Qty Number Number
80 gal. 120 gal.
1 113268-200 113271-200
1 2713 111136-050
1 111136-075 111136-100
1 110514-300 110514-300
1 110512-005 110512-005
1 110513-200 110513-200
1 111089-215 111089-215
1 111491 111491
4 ft. 110515-075 110515-075
2 110948-075 110948-075
1 110945K017 110945K017
7.5 H.P.
1 110258B061
1 110828
1 8930
115/230v, 1Ø 200v, 3Ø
*
1 127466J018 8393
* 230 volt only
Part numbers shown in italics apply to tank mounted units and base mounted units.
(QT-7.5 duplex - horizontal tank - electric motor)
Part
Qty Number Number
120 gal. 200 gal.
1 113467-200 113469-200
2 113281 113281
1 111136-050 111136-050
1 111136-100 111136-100
1 110514-300 110514-300
2 110512-005 110512-005
1 110513-200 110513-200
2 111089-215 111089-215
2 111491 111491
8 ft. 110515-075 110515-075
2 110948-075 110948-075
2 110945K017 110945K017
7.5 H.P.
2 110258B061
2 110828
2 8930
115/230v, 1Ø 200v, 3Ø
1 * 127466J018 8393
* 230 volt only
Part numbers shown in italics apply to tank mounted units and base mounted units.
QT-7.5 Air Master
50121M201, May 2001
Part Part
Number
230/460v, 3Ø
124517-009
Part Part
Number
230/460v, 3Ø
124517-009
Description
tank (200 psi maximum operating pressure)
tank drain valve
service valve
pressure gauge
pressure switch
pressure relief valve (in tank; 200 psi)
pressure relief valve (in discharge line; 215 psi)
check valve
discharge tube
tube fitting, nut with sleeve
belt guard assembly
drive belt
motor pulley
motor bushing
7.5 h.p. motor (O.D.P.)
Description
tank (200 psi maximum operating pressure)
top plate
tank drain valve
service valve
pressure gauge
pressure switch, 135-175 p.s.i.
pressure relief valve (in tank; 200 psi)
pressure relief valve (in discharge line; 215 psi)
check valve
discharge tube
tube fitting, nut with sleeve
belt guard assembly
drive belt
motor pulley
motor bushing
7.5 h.p. motor (O.D.P.)
17
Quincy Compressor
3501 Wismann Lane, Quincy IL 62305-3116