Warner Howard MR48 Operating & Installation Manual

MANUAL
Operating & Installation Manual MR48
Please read and save these instructions. Read carefully before attempting to assemble, install,
or operate the product described. Protect yourself and others by observing all safety information.
Failure to comply with instructions could result in personal injury and/or property damage. Retain
instructions for future reference.
WORLD DRYER MODEL MR48

Description

World warm air hand dryer, powered by universal brush motor, delivers 2500 Watts of drying power. This hand
dryer runs on 220-240 Volts AC electrical supply. An infrared sensor is used to automatically turn the dryer on
and off. This model is intended for use in office and public facility environments

General Specifications

Drying Cycle Air Speed
Automatic

Electrical Specifications

CE IPX1
Electrical Input
220-240VAC/50Hz

General Safety Information

- Always disconnect the power source before servicing or installing this hand dryer
- This hand dryer must be properly grounded (Earthed) for safe operation. An identified Earth connection point is
supplied on the chassis of the hand dryer.
- We recommend GFCI protection in wet or damp locations or as required by local code
- Do not install this hand dryer in any location where bathing or showering is within reach.
- Avoid water entry into the appliance.
- Use only the electrical power (voltage & frequency) specified for this model.
-
Connect the hand dryer to the nearest suitable distribution panel.
- To limit voltage drop, and insure efficient operation, use No. 14 wire or larger.
- In the event of a machine malfunction, disconnect power and contact a qualified electrician
For further information please contact us on :
0370 850 4352 | sales@warnerhoward.co.uk
Air Volume......
30m/s 270m³/h
Amperage Watts...........-
10.4A 2500W
| www.warnerhoward.co.uk
.
O------
.
.
.