Advertisement
2D. RESTORE FACTORY DEFAULTS AND SD CARD INSTALLATION
Make sure the device is powered when attempting to press
Important:
RESET button.
Step 1 Refer Figure 2-7 for access panel location. Remove the panel
to access SD card slow and reset button.
Step 2 Slightly press the RESET button for 15-30 seconds to
complete the factory reset. The camera will reboot when the factory
reset is successful.
www.icrealtime.com
5
|
Figure 2-7
3A. OVERVIEW
The IP Config tool is used to search the local network for IC Realtime
devices as well as modify the IP addresses and upgrading firmware.
This software can be downloaded at:
https://icrealtime.com/downloads
3B. OPERATION
Double click the "ConfigTools.exe" icon to run. The interface will be
displayed as shown in Figure 3-1. Click on the blue circle icon with
the two arrows to refresh and scan the network.
Make sure the network camera is connected to the network
●
and powered properly.
under Desktop Utility Apps
Figure 3-1
Advertisement
