Table of Contents
Advertisement
Fig. 18
Fig. 19
On
Position
Fig. 20
Off
Position
Fig. 21
A
B
C
A
CUTTERHEAD GUARD
It it essential that the jointer is not operated without the
cutterhead guard.
1. Insert post Fig. 19 (A) through the hole in the infeed
table making sure that the spring assembly in the
knob Fig. 19 (C) engages into the slot at the bottom
of the post Fig. 19 (A). You will need to turn the
knob to provide tension in the spring before
inserting post. It is this tension that makes the
guard spring back over the cutterhead.
2. If the tension is too great or too small, adjust by
removing the guard and rotating knob. Fig. 19 (C).
TURNING THE MACHINE ON & OFF
This machine is fitted with a switch that needs to be
pulled out to switch the machine on and pushed in to
switch the machine off. You can also lock the switch in
the off position Fig. 22, by removing the yellow key Fig.
21 (A).
Locked
Position
Fig. 22
7
Advertisement
Table of Contents
