Lamp Replacement - Canon LV-7585 User Manual

Lamp Replacement

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the
screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing
when the LAMP REPLACE indicator should light is depending on the lamp mode.
Top Panel
LAMP REPLACE indicator
✔ Note:
• The Lamp replacement icon will not appear when
the Display function is set to "Off" (p.48), during
"Freeze" (p.28), or "Blank" (p.29).
Follow these steps to replace the lamp.
1
Turn off the projector and unplug the AC power cord. Let
the projector cool for at least 45 minutes.
2
Open the filter cover. (p.57)
3 Loosen the screw and open the lamp cover. Pull out the
lamp by using the built in handle.
4
Replace the lamp with a new one. Make sure that the
lamp is properly and fully inserted.
5
Close the lamp cover and secure the screw.
6
Close the filter cover.
7
Connect the AC power cord to the projector and turn on
the projector.
8
Reset the Lamp counter (p.60)
✔ Note:
• Be sure to insert the lamp in the correct direction.
• Do not reset the Lamp counter when the projection lamp is
not replaced.
CAUTION
Allow a projector to cool for at least 45 minutes
before you open the lamp cover. The inside of the
projector can become very hot.
Lamp replacement icon
Maintenance and Care
Filter cover
CAUTION
For continued safety, replace with a lamp of the
same type. Do not drop the lamp or touch the
glass bulb! The glass can shatter and may cause
injury.
Lamp cover
Handle
Lamp
59