DeWalt DW089K-KR Manual page 26

3 beam line laser
Table of Contents

Advertisement

Available languages

Available languages

E NGL I S H
Magnets
The magnets (t) allow the detector to be mounted to the metal tracks
during the installation of a suspended ceiling.
DETECTOR OPERATION (FIG. 9)
1. Set up and position the laser.
2. Turn the detector on by pressing the power button (q).
3. Position the detector so that the sensor window (u) is facing
the laser beam. Move the detector up or down within the
approximate area of the beam, until you have centred the
detector. For information about the display window indicators
and the audible signal indicators, refer to the table titled
Indicators.
Above
Grade
4. Use the marking notches (p) to accurately mark the position of the
laser beam.
MOUNTING ON A GRADE ROD (FIG. 9, 10)
1. To secure your detector to a grade rod, first attach the detector to
the clamp by pushing in on the clamp latch (v). Slide the tracks (w)
on the clamp around the rail (x) on the detector until the latch (y) on
the clamp pops into the latch hole (z) on the detector.
24
Slightly Above
Grade
fast
fast
beep
beep
INDICATORS
On
Grade
steady
tone
Slightly Below
Grade
slow
beep
Below
Grade
slow
beep

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dw089cg-kr

Table of Contents