Canon CanoScan 8400F Quick Start Manual page 15

Scanning Film
The following steps explain how to scan the film with ArcSoft PhotoStudio.
1
Press the power switch on the scanner's left side to set it to the ( I ) position.
2
Start ArcSoft PhotoStudio.
Refer to step 2 on page 7.
3
Start ScanGear CS.
Refer to step 4 on page 8.
4
Select the [Select Source].
You can select from the following options for films.
Negative Film (Color) / Positive Film (Color)
5
Click [Preview].
ScanGear CS will display the preview image(s).
6
Place a check mark beside the number(s) of the
frame(s) to be scanned.
By default, a check mark appears beside the first frame only.
You can scan multiple frames in one step if you place a check
mark beside the number of each frame you wish to include.
7
Select the [Destination].
You can select [Print (300 dpi)] or [Image display (150 dpi)].
When [Print (300 dpi)] is selected, the output resolution is set
to 300 dpi. When [Image display (150 dpi)] is selected, it is set
to 150 dpi.
[Print (300 dpi)] is selected in this example.
Scanning Film
15