KitchenAid KFGG504KPS Owner's Manual page 20

To Convert Oven Bake Burner (Natural Gas to
Propane Gas)
1. Remove the oven racks and the oven door. See the "Oven
Door" section.
2. Remove two screws and washers at the rear of the oven
bottom.
3. Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven
and set it aside on a covered surface.
A. Screws
B. Oven bottom
4. Remove 1 screw from the bake burner.
5. Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the oven
orifice, and set the bake burner aside.
A. Screws
B. Oven bottom
6. Using a 3/8" (9.5 mm) nut driver or combination wrench, turn
the Natural gas bake burner orifice spud counterclockwise to
remove. The spud will be stamped with a "47."
7. Replace the "47" spud with a "56" spud. Install the Propane
gas bake burner orifice spud, turning it clockwise until snug.
IMPORTANT: Do not overtighten.
A. Orifice spud
20
8. Position the back of the bake burner over the oven orifice, and
slide the tab on front of the bake burner into the front of the
oven.
9. Reattach the bake burner with 1 screw.
10. Position the front of the oven bottom panel toward the front
frame and lower the rear of the oven bottom panel into the
oven.
11. Reattach the oven bottom panel with screws.
To Convert Oven Broil Burner (Natural Gas to
Propane Gas)
1. Remove the screw from the broil burner
2. Remove the flame spreader.
3. Remove the broil burner from the broil burner orifice hood.
NOTE: The broil burner will hang in the back of the oven while
changing the orifice hood.
A. Broil burner
B. Screws
C. Orifice hood
4. Use a 3/8" (1 cm) combination wrench and turn the Natural
gas broil burner orifice hood counterclockwise to remove. The
hood will be stamped with a "155."
5. Replace the "155" hood with a "100" hood. Install the Propane
gas broiler burner orifice hood, turning it clockwise until snug.
IMPORTANT: Do not overtighten.
6. Place the broil burner on the broil burner orifice hood and
insert the broil burner ceramic igniter in the hole in the rear of
the oven.
A. Orifice hood
7. Position the broil burner against the top of the oven and attach
it with 2 screws.
8. Replace storage drawer, warming drawer or premium storage
drawer. See the "Storage Drawer" or "Warming Drawer or
Premium Storage Drawer" section.