Advertisement
Instruction of
To retain your SAT reception, three wires on factory SA T connector need to be moved to the white connector on
Please follow the steps below to accomplish the installation.
Step 1. Unplug the 12-pin blue color factory SAT connector at the back of the radio.
Step 2. Reference the drawing below to disassemble the connectors. Pushing the inner piece of the connector with a small tool
through the open hole at the side of connector. At meantime, push the horizontal bar on the other side of connector upward
to release the latch. The inner piece of the connector will slid out.
Step 3. Referrnce the drawing below, pull out the wire at pin #1 on factory SAT connector with a tool.
Reference the drawing below, raise the key on the pin and insert it into pin #1 of white connector on
Step 4. Referrnce the drawing below, pull out the wire at pin #3 on factory SAT connector with a tool.
Reference the drawing below, raise the key on the pin and insert it into pin #3 of white connector on
Step 5. Referrnce the drawing below, pull out the wire at pin #7 on factory SAT connector with a tool.
Reference the drawing below, raise the key on the pin and insert it into pin #7 of white connector on
Step 6. Pull out the wire at pin #7 of factory SAT connector and insert it into pin #7 of white connector on
Step 7. Assemble the white connector on
Step 8. Plug the white connector on
TO iPod
AUX input
SAT
Step 1:
Unplug factory SAT
connector from the
back of car radios.
Step 2/3:
Connector disassemble illustration.
To pull out wires at pin #1, #3, #7:
pull the wire tight while press
the key by using a pinset as shown.
Cable Installation for VW Equipped with SAT
cable by push the inner piece into the outer piece.
cable CAS-VW6 to the back of radio again.
REAR VIEW
CB-PA14
Back of car radio
Step 4/5/6: Pull out wires at pin #1,#3,#7
and insert into pin #1,#3,#7 of black inner piece
of white connector at CAS-VW6.
To insert the wires into pin #1, #3, #7:
raise the key up as shown,
then insert into the pin hole
4-POSITION DIP SWITCH
ON: when switch is at
CONNECT
bottom position
TO RADIO
FRONT VIEW
TO RADIO
Back of car radio
Step 8: Plug CAS-VW6 to
the back of car radio again
TECH. SUPPORT
( 6 2 6 ) 3 3 6 - 3 8 3 6
9 AM ~ 4 PM PST
M O N
cable.
connector.
connector.
connector.
cable.
1 2 3 4
Blue
connector
~
F R I
Advertisement
