Table Of Contents; Safety Information - Probrite STLR15-PC-4K-BZ Installation, Usage, & Care Manual

TABLE OF CONTENTS

Table of Contents.......................... 2
Safety Information........................ 2
Pre-Installation.............................. 3
Planning Installation............................ 3
Specifications........................................ 3
Tools Required...................................... 3
Package Contents............................... 4

SAFETY INFORMATION

IMPORTANT
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
NATIONAL ELECTRICAL CODE AND LOCAL BUILDING CODES BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED.
PRECAUTIONS
Please read and understand this entire
manual before attempting to assemble,
install, or operate this light fixture.
This light fixture requires a 120-Volt AC
power source.
Some codes require installation by a
qualified electrician.
This light fixture must be properly
grounded.
Make sure connections are secure using
wire nuts, crimp-on lugs or other approved
connecting devices
This light fixture should be installed
outdoors to a wall or eave.
INFORMATION: The device is tested and found to comply with Part 15 of the FCC Rules. Operation is subject
to two conditions: (1) This device may not cause harmful interference and, (2) this device must accept any
interference received, including any interference that may cause undesired operation.
These limits are designed to provide reasonable protections against harmful interference when the
equipment is operated in a commercial environment.
Visit www.probrite.com/install for installation video tutorials and product support
Hardware Included............................... 4
Installation...................................... 5
Operation ....................................... 9
Care & Cleaning............................. 10
Troubleshooting............................ 10
Warranty.......................................... 11
WARNING:
Turn the power off at the circuit
breaker or fuse. Place tape over the circuit
light fixture.
WARNING: Risk of fire. Keep the fixture heads at
least 3 in. (76mm) from combustible materials.
CAUTION: Burn hazard. Allow the light fixture
to cool before touching.
NOTICE: Do not connect this fixture to a
dimmer switch.
NOTICE: FCC Regulations state that any
unauthorized changes or modifications to
this equipment not expressly approved by the
manufacturer could void the user's authorization
to operate this equipment.
2