Table of Contents
Advertisement
OPERATION CONTINUED
1B
SELECT COLOR TEMPERATURE CCT
STLR
Standing within 15 feet, aim the remote control (H) at the front of the
light fixture. Note: IR receiver is behind fixture lens.
The remote has six buttons: ON/OFF, 2700K, 3000K, 3500K, 4000K
and 5000K. Press the buttons to preview the correlated color
temperatures (CCT).
Once you make a selection, keep the light turned on at the selected
color temperature for at least 5 seconds to store the selected color
into memory (this will ensure it always turns on to the last selected
color).
To change light color at any time, point the remote at the fixture lens
(within 15 feet) and select desired color temperature.
CARE AND CLEANING
Shut off main power supply before cleaning the product. To prolong the original
appearance, clean the light fixture with clear water and a soft, damp cloth only.
Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints,
solvents, or any other chemicals on this light fixture. They could cause a premature
deterioration of the finish and may void the warranty.
Do not spray the light fixture with a hose or power washer.
TROUBLESHOOTING
Problem
Light does not
turn ON
Light cycles
ON and OFF
continuously
Visit www.probrite.com/install for installation video tutorials and product support
PC
CCT MODEL ONLY
Possible Cause
No power to the fixture
Fixture is sensing daylight
Photocell light sensor is
sensing reflected light
Check if circuit breaker is tripped
Confirm wall switch is ON
Verify wiring to fixture is correct (turn
power OFF to fixture beforehand)
Cover photocell. Wait several
seconds until fixture turns ON.
Relocate light fixture to a location
where there is no reflected light.
OR place the black cover over
the photocell and use the wall
switch to turn the light fixture
ON and OFF.
10
(fig 15).
Solution
Advertisement
Table of Contents
