DaytonAudio DTA3116S User Manual

SPECIFICATIONS:
Power Output: 15 watts RMS x 2 into 4 Ω and Vcc = 14.5VDC
8 watts RMS x 2 into 8 Ω and Vcc = 14.5VDC
Total Harmonic Distortion: <0.4% @ 1W per channel
Minimum Speaker Impedance: 4 ohm
Signal-to-Noise Ratio: 103 dB, A weighted
Input Impedance: 10k ohms (minimum)
Input Sensitivity: 680 mV
Frequency Response: 20-20,000 Hz (minus 1dB)
Channel Separation: 95 dB
Effi ciency: >90%
Dynamic Range: >100 dB
Electrical Requirement: 14.5VDC @ 4.5A center pin positive
Dimensions: 1.18 H (Faceplate Height) x 2.97" W x 4.33" D (Knob to Speaker Out)
Weight: 1.0 lbs
Warranty Information
Dayton Audio products are warranted free from defects in material and workmanship for 5 years from date
of purchase (see exceptions below). In the rare case of a product failure, please contact your place of
purchase or call our Customer Support Department at (937) 743-8248.
Warranty Limitations
There are no other warranties, either express or implied, that extend the foregoing, and there are no
warranties of merchantability or fi tness for any particular purpose. Dayton Audio is not responsible for any
consequential on inconsequential damage to any other unit or component or the cost for installation or
extraction of any component of the audio system, or for the improper use of products. This includes but is
not limited to burnt voice coils, overheating, bent frames, holes in the cone, or broken lead wires. Warranty
does not apply to misuse, abuse, neglect, accident, improper use, etc. Dayton Audio reserves the right to
repair or replace the products with either a new or factory refurbished unit.
Exception: Dayton Audio HDMI Cables -- No registration, no questions asked LIFETIME warranty.
Replacement of Dayton Audio HDMI cables is with equal or better quality HDMI cables. Unassembled Kits -
A 45-day return policy applies to unassembled kits. Once assembly has been started or completed, kits are
deemed used and are nonreturnable for refund/exchange. This does not limit the manufacturers' warranty
policies on any kit component.
This warranty gives you specifi c legal rights and you may also have other rights that vary from state to state.
Non-Warranty Service: If non-warranty service is required, the product may be sent to the Company for
repair/replacement, transportation prepaid, by calling (937) 743-8248 for details, complete instructions, and
service fee charges.
daytonaudio.com
tel + 937.743.8248
info@daytonaudio.com
Dayton Audio
®
705 Pleasant Valley Dr.
Springboro, OH 45066
USA
Last Revised: 11/3/2015
CLASS D MICRO
MINI AMPLIFIER
Model: DTA3116S User Manual