Canon BJC-S300 Setup Instructions

1
Unpack the Printer
1 Carefully remove all items from the box.
S300 Series
Color Bubble Jet Printer
Paper Rest
Output Tray
Documentation
and Software Kit
S300 BJ (Bubble Jet) Printhead Power Cord
Ink Tanks
BCI-24 Black BCI-24 Color
2
Prepare the Printer
Remove the shipping tape from the front
1
and sides of the printer.
Shipping Tape
Plug the power cord into the back of the
2
printer and connect the other end to a
power outlet.
Press the POWER button.
3
POWER POWER
Button Light
4 Open the front cover. The printhead holder
automatically moves to the center.
Serial number
Write down the serial number located to
5
the right of the printhead. You will need
this later to register the product.
Start Here
Easy Setup Instructions
3
Install the Printhead
Remove the printhead from its package.
1
Turn the printhead over, then remove
2
the orange protective cap.
NOTE: Do not touch the electrical contacts.
Electrical contacts
Raise the gray lock lever.
3
4 Gently slide the printhead into the holder
until it is securely seated.
Do not press it down.
Lower the lock lever until it locks into place.
5
4
Install the Ink Tanks
1 Remove the black ink tank (BCI-24 Black)
from its packaging and pull off the orange
protective cap.
Protective cap
NOTE: To avoid spilling ink, do not touch the
bottom of the tank once you have removed
the protective cap.
Insert the black ink tank into the slot on the
2
right. Press down gently until the ink tank
locks into place.
Repeat the procedure for the color ink tank
3
(BCI-24 Color), inserting it into the remaining
slot.
Close the front cover and attach the
4
paper rest and output tray.
Color Bubble Jet Printer
™
S300
5
Connect the Printer
To Your Computer
Turn the printer off.
1
IMPORTANT: Be sure printer is
off before continuing, or the
computer will attempt to install
the printer driver before the
printer is ready.
2 Connect one end of a USB cable (not
included) to the computer, the other to
the printer.
USB Port
USB Cable
Continue with Step 6
on side two.