Advertisement
5.4.
Attach the bottle jack fig.3
5.4.1.
Hook one end of tension spring (#8) to main frame (#1). fix another end to Hook (#11), insert the hooks (#11) through the hole on jack
plate (#12), secure with wing nut m8 (#12). repeat for the other side.
5.4.2.
Place the bottle jack (#5) to jack base plate (#2), fix by using hex socket round head screw M8x20 (#14) and lock washer Ø8 #17).
5.4.3.
Adjust the wing nut (#12), so that the tension springs is in the working state, the bottle jack can be free to return to the position.
Fig.3
5.5.
Attach press platform fig.4
5.5.1.
Attach the press platform (#3) to main frame (#1), insert support rod (#9) to secure the press platform. Put the two press plates (#7) on
the platform.
6. preparation For use
6.1.
Secure press to the bench/floor
WarninG! Always use another person when moving the press
‰
6.1.1.
move the press to the mounting location and drill four mounting holes in the feet of the press.
6.1.2.
make a template to mark the spots where the four holes will be drilled in the bench.
6.1.3.
check for any hidden wiring or cables, if needed change the location for the holes.
6.1.4.
temporarily move the press to the side.
6.1.5.
use a masonry drill bit to drill the four holes about 3"to 4" deep into the concrete or wood.
6.1.6.
clean out the drilled holes and insert lag screw anchors (not included) into the holes.
6.1.7.
Position the press and align the holes in the feet with the holes in the bench.
6.1.8.
use four concrete anchor bolts or lag bolts (not included) to secure to the bench.
note: this press needs to be mounted to a bench of either concrete or wood, capable of supporting the weight of press and any
workpiece.
WarninG! to prevent serious injury do not use damaged equipment. if abnormal noise or vibration occurs have the problem
‰
corrected before further use.
Before first use
6.2.
6.2.1.
Before using the press check the hydraulic oil level in the bottle jack.
6.2.2.
test the jack several times to make sure it operates correctly before actual use. if the jack does not work properly, bleed the excess air
following these steps:
a. open the release valve.
b. Remove the oil plug and fill the jack with hydraulic fluid to full level.
c. Apply pressure to the saddle and pump the handle up and down several times.
d. check the oil level and if necessary top off with hydraulic oil.
e. replace the oil plug and close the release valve.
f. test the jack several more times for proper operation before using.
note: if after bleeding the excess air the jack will still not operate properly do not use the press until it has been repaired or
replaced.
7. operation
7.1.
use the support rods (#9) to adjust the height of the press platform (#3).
note: the press platform needs to be in the highest position with the workpiece as close as possible to the ram of the jack plate.
7.2.
Place the workpiece on the press plates (#7).
WarninG! make sure there are no obstructions under the press plates. obstructions will create an uneven surface which can cause
‰
the press plates to break under pressure.
WarninG! When pressing two items together the items need to line up vertically. if they are not lined up one item may forcefully eject
‰
sideways from the unit.
7.3.
Put the handle (#18 Parts diagram only) in the jack sleeve and move the jack plate down until the ram of the jack plate contacts your
work piece.
© Jack sealey limited
Fig.4
Original Language Version
YK6ecB.V2 | issue:2 (3) 20/08/18
Advertisement
