Maintenance And Care - Flex RC-ALC 3/360 Original Operating Instructions

RC-ALC 3/360
For vertical laser line, set laser receiver on its
side, move the receiver field (2) of the laser
receiver through the laser lines from side to
side until the center LED lights up. Now mark
the vertical reference dimension.
NOTE
To use this laser receiver with laser levelling,
ensure the laser levelling must be set at
outdoor working mode.
NOTE
Ensure the laser line projected on the receiver
field must parallel with center line, otherwise
the laser receiver doesn't work.
NOTE
It may cause a long alarm when the tool
affected by strong interference, such as direct
sunlight, too close to a fluorescent lamp or
a display, etc.; Please keep the tool away
from the interference and the tool can work
normally again.
CAUTION!
Minimum distance from the laser device
is about 3 m. Pay attention that the laser
lines are not reflected by reflective
surfaces. Such reflections can lead to false
indications.
D1: Slow beeping (lower LED)
D2: Continuous tone (middle LED) = mark
the reference
D3: Rapid beeping (upper LED)
CAUTION!
The light intensity of the laser lines is greatest
at the center and diminishes toward the ends.
This can reduce the maximum reception
range of the laser receiver.
Using bracket or magnet to secure the
laser receiver in place (see figure E)
To use the bracket
Attach the laser receiver onto the bracket
(4), clamp the bracket to a secured object by
using locking knob (3). The horizontal bubble
(11) will helps to level the bracket.
NOTE
the maximum capacity of the bracket (W) is
more than 55 mm
To use the magnet
There are two sets of magnets, one set is located
on the top, the other is located at the back.
Attach the laser receiver to ferromagnetic
area with these integrated magnets.
NOTE
The distance between the top and the center
LED indicator is 30mm
Danger - powerful magnetic
fields
Powerful magnetic fields can adversely affect
persons with active medical implants (e.g.
pacemaker) as well as electromechanical
devices (e.g. magnetic cards, mechanical
clocks, precision mechanics, hard disks).
With regard to the effect of powerful
magnetic fields on persons, the applicable
national stipulations and regulations must
be complied with such as BGV B11 §14
„electromagnetic fields" (occupational health
and safety - electromagnetic fields) in the
Federal Republic of Germany.
To avoid interference/disruption, always keep
the implant or device a safe distance of at
least 30 cm away from the magnet.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the laser receiver.
Cleaning
■ Keep the measuring tool clean at all times.
■ Do not immerse the measuring tool in
water or other fluids.
■ Always keep the product free of dust and
liquids as much as possible. Use only a
clean, soft cloth for cleaning. If necessary,
slightly moisten the cloth with pure alcohol
or a little water. Do not use any cleaning
agents or solvents. Do not Wash with water
directly.
Spare parts and accessories
For other accessories, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
11