Mitsubishi Electric MA-E100R-E Instruction Manual page 15

Do not use detergent, scouring powder, chemically-treated
cleaning cloth, gasoline, benzene, thinner, etc. This may
damage the main unit.
HEPA filter, Pre-filter
1
Remove the inlet panel.
2
Remove and clean the pre-filters (x2).
Suck up the dust with a vacuum
cleaner using a nozzle with a
brush.
<When the dirt is severe>
Wash with water using a soft
sponge, etc., and dry thoroughly.
3
Clean the HEPA filter.
Suck up the dust with a
vacuum cleaner using a
nozzle with a brush.
l The material on the reverse side of the HEPA
filter is weak, so do not apply suction to it
with a vacuum cleaner.
l Do not wash it with water.
4
Install the pre-filters and inlet panel
onto the main unit.
P10
P10
WARNING
Approximately Once a Month
Odor sensor, PM2.5 Sensor
1
Remove the inlet panel.
2
Suck up the dust with a vacuum
cleaner using a nozzle.
Odor sensor
PM2.5 Sensor
Located on the right side of the main unit.
3
Attach the inlet panel to the main
unit.
P.10
Remove the power plug before
cleaning.
This may cause electric shock or
injury.
P.10
15