Mitsubishi Electric MA-E100R-E Instruction Manual page 10

Preparation
Take the activated charcoal filter out of its plastic bag and then install it.
1
Remove the inlet panel.
Pull the inlet panel toward you while pressing the levers at the
bottom.
2
Remove the filters.
1 Pre-filter (×2)
Remove the filter while
holding the tabs.
2 HEPA filter
Remove the filter while
holding the tab.
3
Remove the activated charcoal filters and
then take them out of its plastic bag.
The distribution of charcoal may be uneven and there may be
black charcoal powder in the plastic bag, but this will not affect the
performance.
10
4
Attach the filters to the main unit.
1 Activated charcoal filter (×2)
Push the filter all the way
in.
2 HEPA filter
Confirm the installation orientation
and then push the filter all the way
in.
Do not push this surface downward.
This may cause deformation.
Position the tab so that it is
protruding out toward you.
3 Pre-filter (×2)
Insert the eight tabs at the left and right of
the filter into the eight holes in the main
unit. (There is no top and bottom.)
Hole in the main unit
5
Attach the inlet
panel to the main unit.
Align the inlet panel with both edges of the main unit and then
hook the two tabs at the top of the inlet panel onto the main unit
and firmly push in the bottom.
Tabs at top (2
places on back
side)
Write the filter use start date on the filter replacement sticker on
the right side of the main unit.
Position the tab at
the top so that it
is protruding out
toward you.