Table of Contents
Advertisement
Quick Start Guide
SDC-WB40NBT
Laird CLI Basics
The Laird CLI provides a command line interface to control the Wi-Fi features of the WB40NBT.
The Linux shell prompt is represented by the "#" symbol. From the prompt, enter sdc_cli to start the Laird
CLI. When the Laird CLI starts, the prompt will change to "sdc#".
Full information on the commands available within the CLI is available in the SDC_CLI guide, which is found in
the Documentation tab of the
Information regarding using the CLI commands is also available by typing help at the sdc# prompt.
Additional help is available for the commands iface, profile, global and auto-profile using the syntax
<command> help at the sdc# prompt.
To see the status of the WB40NBT, type status at the sdc# prompt. The returned status should resemble
the following.
Status: AP mode
Config name: Default
SSID:
Channel: 0
RSSI: 0
Device Name:
MAC: 00:17:23:e0:38:e4
IP: 192.168.1.1
AP Name:
AP MAC:
AP IP:
Bit Rate: auto
Tx Power: 0 mW
Beacon Period: 0
DTIM: 0
To exit from the sdc# prompt at any time, enter the command exit. You will be returned to the Linux shell
prompt, #.
WB40NBT File System
This section details some important contents of the WB40NBT file system. For more in depth information
consult the WB40NBT reference manual.
Table 1: Main components
Directory
/usr/bin
/usr/lib
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
WB40NBT product page at
Content of note
sdcsupp
sdc_cli
libsdc_sdk.so.1.0
libsdc_sdk.so.1
9
lairdtech.com.
Comment
Laird Supplicant
Laird CLI
Laird SDK library
A symbolic link to SDK library
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
Advertisement
Table of Contents
