EESiFlo Portalok 7S Simplified Installation

EESiFlo Portalok 7S Ultrasonic Flow Computer
Setup and Installation of the Portalok 7S Ultrasonic Flow Computer involves three simple steps.
 Define the Parameters of the Pipe and Fluids (PAR on the main menu)
 Select the Output Options (OPT on the main menu)
 Enter the Measure Mode (MEA on the main menu)
Defining the Pipe and Fluid Parameters >PAR<
1) Plug the Transducer into the receptacle marked
2) Turn the instrument
3) Using the Arrow keys scroll to
4) Enter the pipes
arrow key to move to the next position then press
the pipe size. For example a 2 inch pipe has an Outside Diameter of 2.375 inches.
5) Next, enter the pipe
Pipe Material
6) Select a
ENTER
press .
YES
7) Answer or
(using the arrow keys) and then the
8) Enter the internal
ENTER
9) Using the arrow keys, select the
10) Enter the approximate
Additional cable
11) Enter
return to the main menu.
Toll Free: 866-337-4356
Simplified Installation of the
ON
by pressing the
PAR
(parameters) on the main menu and press
Outer Diameter
by using the Down arrow key to change the values and the right
Wall Thickness
using the arrow keys to scroll up and down through the available list then
NO Lining
to the prompt for
Lining Thickness
Roughness
of the pipe (this is an estimate, if unknown leave as default) then press
Medium
Medium Temperature
length (if no extension is used select 0) then press
219 East Main Street
Mechanicsburg, PA
USA, 17055
Fax: (717) 697-2122
Transducer
.
PWR
button
ENTER.
Remember, this is the OD of the pipe not
using the arrow keys then press
. If you answered
(Liquid Type) from the available list then press
ENTER
then press
ENTER
ENTER
YES Lining Type
, then enter the
.
ENTER
and you will
.
ENTER
.