Advertisement
For Alpha Intec –
•
Gain access to the boiler terminal block as described in the boiler installation
and service instructions.
•
Pass the wire from the Climatic controller through the rubber grommet in the
terminal block cover
•
Connect it to terminals 12 & 13.
•
Remove link wire from terminals 1 & 2
•
(DO NOT connect Climatic wires into terminals 1 & 2!)
•
Secure the wire under the cable clamp and re-assemble in reverse order.
For Alpha Intec –
•
Gain access to the boiler terminal block as described in the boiler installation
and service instructions.
•
Remove the screws from the fixing posts in the back of the control panel,
position the receiver and re-fit the screws to secure it in place.
•
Connect the wires from the receiver terminal to the BUS connections 12 & 13
on the boiler terminal block (the wires can be connected either way round).
Hard Wired
RF Wireless
8
Advertisement
