Removing The Bath Lift - Invacare Aquatec Beluga User Manual

Beluga Bath Lift
The pins on the fixation ring D fit in the guides F on the seat plate.
The spindle B is released from the catch A.
The spindle foot E is in the spindle foot retainer of the base plate.
The ratchet C locks the spindle foot.
6. Hold the charged battery B by the grip A and insert into the guide
C in the backrest from above.
7. Push the battery down completely.
The battery should click into place.
The bath lift is now ready for use.

4.4 Removing the bath lift

1. Let the water out of the bathtub.
10
2. Lower the bathlift A by pressing the Down button, until the back-
rest is at the stop. See Section 5.2 Controlling the bath lift.
!
IMPORTANT
▸ Grasp deep into the grip so that you can hold the battery
safely.
3. Unlock the battery by pulling the grip up slightly.
4. Pull the battery upwards out of the guide B.
!
IMPORTANT Risk of damage
▸ When folding the backrest down, ensure that spiral cable of
the hand control does not get caught.
▸ Do not fold the backrest down if there is water in the
bathtub.
5. Hold the backrest at the head end with one hand.
6. With your other hand, hold the spindle near the red spot.
7. Push the spindle forward and at the same time slowly fold the back-
rest all the way forward C.
8. Press the spindle into the catch.
9. Pull the backrest up off the seat and out of the bathtub D.
10. Fold the side flaps of the seat inwards E.
!
IMPORTANT
▸ Release both rear suction cups simultaneously.
11. Release the rear suction cups by pulling up on the protruding tab.
12. Lift the rear of the seat further F. This releases the front suction
cups.
!
IMPORTANT
▸ If the height adapters have been installed (optional), you also
have to pull the tabs of the front suction cups to release
them.
13. Take the seat out of the bathtub.
14. Carefully put away all components of the bath lift.
Setup and installation