I: Setting The Iso Speed - Canon EOS 50D Instruction Manual

The maximum burst is displayed even when a card is not in the camera.
Make sure that a card is loaded before taking a picture.
The maximum burst for <o> is displayed regardless of the drive mode
setting.
If [8C.Fn II -2: High ISO speed noise reduction] is set to [2: Strong],
the maximum burst will be reduced (p.176).
If the viewfinder displays "99" for the maximum burst, it means the maximum
burst is 99 or higher. If 98 or lower is displayed, the maximum burst is 98 or
lower. If you stop the continuous shooting, the maximum burst will increase.
After all the captured images are written to the card, the maximum burst will
be as listed on page 61.
i: Setting the ISO SpeedN
Set the ISO speed (image sensor's sensitivity to light) to suit the
ambient light level. In the Basic Zone modes, the ISO speed is set
automatically (p.64).
3 Setting the Image-recording Quality
Press the <m> button.
1
Set the ISO speed.
2
While looking at the LCD panel or
viewfinder, turn the <6> dial.
It can be set within ISO 100-3200 in
1/3-stop increments.
When "A" is selected, the ISO speed
will be set automatically (p.64).
(
9 )
63