Demounting; Demounting Steps - Bosch Rexroth IndraControl XFE01.1-SY-01 Operating Instructions Manual

IndraControl XFE01.1-SY-01 Safety Ex-
tension Module

10.4 Demounting

WARNING
Disconnect the complete station and the components before demounting the
components! Connect the voltage only again after demounting.
To demount, use a common tool such a slotted screwdriver with a
2.5 mm blade.

10.4.1 Demounting steps

NOTICE
Before mounting or demounting components, disconnect the control - including
its components - from voltage.
Removing extension modules from top-hat rail
1. Remove the left end clamp.
2. Use a suitable tool (e.g. slotted screwdriver) and put it first into the upper
and then into the lower disengaging mechanism (base latch) of the control
and disengage the control (see (A) in the following figure). The base
latches are locked in the open position.
3. Remove the extension module vertically to the mounting rail (see (B) in the
following figure). The base latches engage again in idle position.
Mounting, demounting and electric installation
Do not demount the control, modules or plugs
under voltage.
accidentally!
Destruction of components due to demounting
under voltage!
R911376654_Edition 03 Bosch Rexroth AG
The system might
25/45
start