Cambridge SoundWorks Control Clock 88 User Manual page 2

Thank you for purchasing the Control Clock 88 by Henry Kloss. It adds
"clock radio" functions to your Model 88. Place your Model 88 anywhere
in the room. Your Control Clock 88 keeps all essential control functions
close at hand.
The Control Clock 88 offers the convenience of two separate alarms.
Either may be set to tone wake-up, music wake-up, or both. See next
page for alarm setting instructions.
Please read this operation manual to receive maximum benefit from your
Control Clock 88. Save this manual for future reference.
IMPORTANT: Remove battery when unit is not
connected to AC Power for more than an hour.
CONTROL CLOCK 88
MANUFACTURED UNDER LICENSE FOR CAMBRIDGE SOUNDWORKS, INC.
311 NEEDHAM ST., NEWTON, MASSACHUSETTS 02464 USA
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION
IS SUBJECT TO THE CONDITION THAT THIS DEVICE DOES NOT CAUSE
HARMFUL INTERFERENCE.
DO NOT EXPOSE TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
MADE IN CHINA 117VAC 50/60Hz 1 Amp
Figure 1
Setting up
Installing a 9-volt battery maintains accurate time in case of a power
outage. Install it in the bottom of the unit (see Figure 1). An alkaline
battery is recommended.
During a power outage, the display will not light up. If the Control Clock
88 "TONE" alarm was on when the power was interrupted, it will still
function. The "RADIO" wake-up will not work during a power outage.
The battery maintains time and alarm settings for approximately 48
hours. Remove the battery if the unit is unplugged for more than an hour
or so. The low battery indicator (see Figure 2) will light if the battery
needs replacement or power is interrupted. After battery replacement or
when power is restored, this indicator may take 15 minutes to
disappear. This is normal. Verify time and alarm settings after battery
replacement.
Placement
The Control Clock 88 tone alarm is most effective when the unit is
placed on a hard, flat surface. If the unit is placed on a soft cloth
surface, the tone output level may be reduced.
Plug the Control Clock 88 into an unswitched AC outlet.
Battery
Place the Control Clock 88 in a convenient location.
Compartment
Place your Model 88 in its best sounding location. You may wish to
adjust the Model 88's subwoofer control for optimum bass output. Test
the remote control functions of the Control Clock 88 to verify proper
operation. Adjust the Control Clock 88's directional emitter as necessary
Opening for to establish control of the Model 88 (see Figure 4).
alarm tone