Subscribe to Our Youtube Channel
Related Manuals for Cambridge SoundWorks MegaWorks 210D
Summary of Contents for Cambridge SoundWorks MegaWorks 210D
- Page 1 P O W E R E D S A T E L L I T E / S U B W O O F E R S Y S T E M U S E R M A N U A L...
-
Page 2: Important Notice
The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute risk of electric shock to persons. WARNING DO NOT OPEN TO PREVENT THE RISK OF ELECTRIC... -
Page 3: Important Safety Instructions
Use a damp cloth for cleaning. ATTACHMENTS – Do not use any adapters or attach- ments not recommended by Cambridge SoundWorks as they may cause hazards. WATER AND MOISTURE – Do not use the speaker near water-for example, near a bath tub, wash bowl, kitchen sink, or laundry tub;... -
Page 4: Table Of Contents
Examine the speaker system carefully for shipping damage. If there is any, do not install or use the sys- tem. Return the speaker to the store where you made the purchase or call Cambridge SoundWorks at 1-800 FOR-HIFI (1-800-367-4434) for assistance. After Unpacking Store the shipping carton and packing material for future transport needs. -
Page 5: Carton Contents
J) Stereo Signal Cable, Green Miniplug to Green Miniplug Plugs into analog LINE IN A or LINE IN B Connect to any analog sound source with a 3.5 mm stereo output jack, like Cambridge SoundWorks MusicWorks ™ , a portable CD player, a small headphone jack, or a computer sound card. -
Page 6: Setup Options
SETUP OPTIONS Cambridge SoundWorks, Inc. supplies screws and plastic anchors for convenience, but it is the speaker purchaser’s responsibility to insure that any speaker placement is secure, stable and reliable. Cambridge SoundWorks assumes no responsibility for damage to its products or any damage to property resulting from speaker positioning or placement. - Page 7 Wall Mounting With A Swivel Bracket Contact Cambridge SoundWorks about available swivel brackets. F) Follow the installation instructions for your particu- lar mounting bracket to attach it to a flat surface. You can install the whole bracket/satellite assembly inverted. This places the bracket above the satel- lite, concealing it when viewed from below.
-
Page 8: Connection Diagram
CONNECTION DIAGRAM DIGITAL OUT Yellow/Orange plug – to a minijack digital output (for instance, a Sound Blaster Live! 5.1 sound card) Digital Signal Cable BASS TREBLE Analog Signal Cable Green plug – to a stereo minijack analog output (MusicWorks, sound card, portable CD player) 8 8 8... - Page 9 SPEAKERS DIGITAL IN LINE IN VOLUME CONTROL 120VAC 60Hz POWER RISK OF FIRE REPLACE FUSE AS MARKED...
-
Page 10: Positioning Your Speakers
Do not place it on a desktop or shelf. For maximum bass output, place the subwoofer near a corner. If the subwoofer is placed away from the inter- section of two room surfaces, the maximum bass out- put will be reduced. - Page 11 Place the satellites as close to the edge of the shelf as possible for best sound (diagram D). Close EAR LEVEL SLIGHTLY HIGHER 11 11 11 11 Close MAXIMUM RECOMMENDED DISTANCE APART FOR HOME THEATER 45 ANGLE LEVEL WITH CENTER SPEAKER POWERED SUBWOOFER Flush with edge if possible...
-
Page 12: Connections
Volume Control onto the support strut on one of the stands. B) Insert the Volume Control’s plug into the jack marked VOLUME CONTROL on the Subwoofer input panel until it snaps in place. It is not necessary to connect the Volume Control if your audio signal source provides an output level adjustment you would rather use. - Page 13 Other Connection Situations 1) Using the MegaWorks 210D as a high performance stereo television sound system. a) A stereo television with audio signal output typically has two RCA-type jacks (one red, one white). To connect to these jacks, obtain a stereo signal cable with two RCA plugs at one end and a 3.5 mm...
- Page 14 2) Using the MegaWorks 210D as a sound system for a component CD player. Typically, there are two RCA-type jacks (one red, one white) on the CD player. To connect to these jacks, obtain a stereo signal cable with two RCA plugs on one end and a 3.5 mm stereo miniplug at...
- Page 15 Right channel satellite. Repeat the preceding process to connect the other satellite (making it the Left channel satellite). AC Connection and Placement Make sure the subwoofer Power switch is in the OFF 120VAC 60Hz position (O). POWER Plug the supplied power cable first into the subwoofer back panel AC socket.
-
Page 16: Final Adjustment
OPERATION AND FINAL ADJUSTMENT 1) Use the Volume Control or the signal source control to vary output level. 2) Defeat or cancel any “tone control” or other sound adjustments within your audio program source. Portable CD players may have “bass boost” switch- es and many computer sound programs have audio adjustments concealed in drop-down menus. -
Page 17: Specifications
Amplifiers: Satellite: 60 watts continuous at 1 kHz, two channels driven at less than .1% total harmonic distortion. Subwoofer: 150 watts continuous at 100 Hz, one chan- nel driven at less than .3% total harmonic distortion. System Frequency response: Satellite: 150 Hz to 15 kHz, +/- 3 dB... - Page 20 CAMBRIDGE SOUNDWORKS, INC. 311 Needham Street, Newton MA, 02464 Telephone: 1-800-367-4434 Fax: 1-617-527-3194 Company P81-1750...
Need help?
Do you have a question about the MegaWorks 210D and is the answer not in the manual?
Questions and answers