Composite-ARF CARF-Models Spitfire Building Instructions page 22

Wing assembly (Aileron
installation)
The aileron is held in place with a
1mm rod. Make a Z bend in the end
of the rod as shown in photo.
Working through the opening under
the flap, use a small bead of epoxy
to glue the pin to the top of the wing.
Tail wheel Installation
Composite ARF offers a lightweight
composite tail wheel assembly. A
few photos are included to aid in
installation of this unit. We chose an
optional steerable tail wheel for our
prototype. An access hole needs to
be cut in the rear for installation of
the tail wheel. Care must be taken to
reinforce the rear of the fuse after
cutting the hole. An 1/8 piece of
plywood will need to be cut to fit in
the location shown and will be
attached to two hardwood rails glued
to the side of the fuse. See photos
below for details
Composite-ARF Spitfire 22