Cambridge Audio One+ User Manual page 17

Connections (continued)
Note: Do not plug in the mains power lead or turn the unit on until all connections
have been made.
Loudspeakers
1
Check the impedance of your speakers. Speakers with an impedance of between 4
and 8 Ohms are recommended.
The coloured speaker terminals are positive (+) and the black speaker terminals are
negative (-). Make sure correct polarity is maintained at each speaker connector or
the sound can become weak and "phasey" with little bass.
Prepare the speaker cords for connection by stripping off approximately 10mm (3/8")
or less of the outer insulation. More than 10mm could cause a short circuit. Twist the
wires tightly together so there are no loose ends. Unscrew the speaker terminal knob,
insert the speaker cable, tighten the knob and secure the cable.
Note: All connections are made using standard loudspeaker cable. If an active
subwoofer is used, connect via a standard single RCA/phono cable (often referred to
as a 'Sub-Link').
2 Aerial
.
Extend and move the aerial until you get the best reception.
One+ has an F-type screw connection and the attached aerial can be removed and
replaced with an optional outdoor DAB & FM aerial if required.
To remove the aerial, feed the supplied aerial key through the aerial and turn the key
counter-clockwise.
17
3 DD30 docking station
Connect the supplied DD30 docking station to the connector located at the rear.
Note: The plug is polarised and only fits one way. Insert the plug gently.
4
Active subwoofer
Connect to an active subwoofer using a standard RCA/phono cable.
5
Aux 1 & 2 inputs
For other sources such as the audio outputs of a DVD player, satellite/cable receiver
etc.
6 Tape output
For connection to the recording inputs of a tape machine, CD-R recorder etc.