Getting Started - VTech 4-in-1 Learning Letters Train Instruction Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover on the back of
the electronic activity panel. Use a
screwdriver to loosen the screw and
then open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 3 new AA batteries following the
diagram inside the battery box. (For
best performance, alkaline batteries
or fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery cover and tighten
the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
5
5
5