Frigidaire FHPC082AC1 Use & Care Manual page 12

Operating Instructions
How to Use the Remote Control
TURNING THE UNIT ON
Plug in the unit, then press the "
before shutdown.
To switch the unit off, press "
Do NOT switch the unit off by removing the plug.
Always switch the unit off by pressing the "
Cool mode
Press the "Cool" button to activate the cool mode.
Press the " fan speed" button to choose the fan speed "auto", "high" and "low".
Press the " " and "
Dry mode
Press the "Dry" button to activate the dry mode.
In this mode, the "
drain moisture from the room.
Note:
In this mode, the fan speed will be set as "low" automatically, which cannot be changed.
In this mode, condensate drainage are required, refer to the "Drainage Instructions" on Page 14 for more
instructions to drain the excess condensate.
Fan mode
Press the "FAN" button to activate the Fan mode.
In this mode, you can select fan speed "high" or "low" by pressing the Fan speed button and referring to
the diagram.
Note: In this mode, the air exhaust hose does not need to be connected.
Auto mode
Press the "Auto" button to activate the auto mode.
Press the " " and "
select cooling, heating(not applicable for cooling only models), or fan only operation depending on what
temperature you have selected and the room temperature. The air conditioner will control room temperature
automatically round the temperature point set by you.
Note: In this mode, fan speed cannot be selected.
" button (when turned on, the unit will operate as the last setting
" button again, then remove the plug.
"button to choose the temperature you want.
" or " " button is disabled and the screen will remain blank. The unit will continuously
" button to choose the temperature you want. In this mode, the unit will automatically
" button and wait for few minutes before removing the plug.