Table of Contents
Advertisement
Quick Links
Fire Sentry Corporation
23311 La Palma Avenue
Yorba Linda, California 92887
Radiant Energy Fire and Flame Detector
Fire and Flame Detectors
MODEL FS17X
Installation Guide
Operating Manual
____________________________________________________________________________________________________________________
Fire Sentry Corporation
FS17X WideBand IR
Multi-Spectral Infrared Electro-Optical
Digital WideBand IR Sensor
FSX
and
Document No. 6178-007 - Rev. F
Telephone: 714-694-2700
Fax: 714-694-2701
www.firesentry.com
TM
TM
P
P
TM
©
Copyright 2012
All Rights Reserved
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Fire Sentry FSXP
Summary of Contents for Fire Sentry FSXP
- Page 1 Fire Sentry Corporation Telephone: 714-694-2700 23311 La Palma Avenue Fax: 714-694-2701 Yorba Linda, California 92887 www.firesentry.com FS17X WideBand IR Multi-Spectral Infrared Electro-Optical Digital WideBand IR Sensor Radiant Energy Fire and Flame Detector Fire and Flame Detectors MODEL FS17X Installation Guide...
- Page 2 Room Sentry, COP-i, Complete Optical Path Integrity, CM1, CM1-A, DartLogic, FireLogic, Fire Signature Analysis, FireBusI, FireBusII, FirePic, FirePicII, FirePicIII, FirePix, FirePicture, FSC, Fire Sentry Corporation, Fire Sentry Corp., FSX, All FSX Nomenclature Variations (such as: FS2, FS2X, FS2X, FS3, FS3X, FS3X, FS4, FS4X, FS4X, FS5, FS5X, FS5X, FS6, FS6X,...
-
Page 3: Table Of Contents
Drawings ............................19 4.4.1 Outline and Dimensions ......................19 4.4.2 Wiring and Terminal Connections ..................20 4.4.3 Detector Label Drawings ....................... 24 I NDEX ..................................25 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved... -
Page 4: Section 1: Introduction
Fire Verification Time: 5 or 10 second Relay Outputs: Latching or Non-latching Detection Sensitivity: High or Low Digital Communication Address: 0 to 32 Page 1 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved... -
Page 5: Detector Technical Specifications
0.7 to 1.1 micron wavelengths WideBand IR 1.1 to 3.0 micron wavelengths 1.2.5 Area Classifications Class , Division 2 Class , Zone 2 Page 2 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved... -
Page 6: Features & Benefits
Three Separate Bright LEDs (Red, Yellow, Blue) for quick, easy identification of ALARM, Fault and Normal status for semiconductor clean room environments. Our Windows® based PC Software for remote FSX diagnostics and data retrieval. Designed, Manufactured, Tested, and Patented by Fire Sentry Corporation (30 years of proven fire / flame detection product excellence worldwide). Applications... -
Page 7: Section 2: Installation
Do not attempt to modify the Model FS17X Detector as this voids all warranties. CAUTION: Disconnect electrical power before unscrewing the Housing Lid. Page 4 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved... -
Page 8: Detector Connections
Follow static protection procedures while handling the connectors and the wiring of the FS17X Detector. Use a wrist strap connected to earth ground. Page 5 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved... - Page 9 Follow static protection procedures while handling the connectors and the wiring of the FS17X Detector. Use a wrist strap connected to earth ground. Page 6 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved...
- Page 10 Follow static protection procedures while handling the connectors and the wiring of the FS17X Detector. Use a wrist strap connected to earth ground. Page 7 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved...
-
Page 11: Installation Practices
“end to end”. Using our external FSX hand-held test lamp ensures that the FS17X Detector has a clear unobstructed view of the threat area and the Detector is aimed properly at the fire threat area. Page 8 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012... - Page 12 The TL-1055X and the TL-2055X are the ONLY Test Lamps that will activate the FSX Detectors. Additionally, do not use these Test Lamps to activate other Fire Sentry Detectors such as the Models SS2 or SS4 (nor any other conventional fire and flame detectors). Do not use other Fire Sentry Test Lamps to test the FSX Detectors.
- Page 13 Remember to disable the Detector outputs, as a full functional test includes activating the alarm outputs. A FSX Fire Sentry Test Lamp must be used for this test (Section 4.3). Point the Test Lamp directly at the front of the Detector (on axis as much as possible, within a distance of 1 to 25 feet). Activate the Test Lamp by pressing and holding its pushbutton.
-
Page 14: Section 3: Operation
0.7 to 1.1 microns. The Visible Band and NearBand IR are used primarily to further discriminate against non-fire false alarm sources. As with all Fire Sentry Corporation Detectors, the Model FS17X Detector senses radiant energy generated by both hydrocarbon and non-hydrocarbon fires. -
Page 15: Led Status Indicators
(sink 20 mA) Fire Verifification Output RS-485 FireBus ALERT Notification RS-485 FireBus ALARM Notification Figure 3-2 1 Only one active output from this group Red LED Location Page 12 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved... -
Page 16: Fault
2 Only one active Fault output from this group Yellow LED Location The FS17X has the following Fault (Trouble) outputs: Flashes LED Fault Cause Remedy Contact Fire Sentry Corporation to speak Yellow Self Test Fault Sensor response is out of range. with a Technical Representative. -
Page 17: Maintenance
Additionally, semi-annual or quarterly testing should be performed, using the correct Fire Sentry Test Lamp, to ensure the integrity of the entire fire protection system. (see Note in Section 2.4 and Section 4.3) Clean the FS17X Detector window: Each time the Detector is taken out of or put back into to service. -
Page 18: Section 4: Appendix
Fire Sentry Corporation assumes no obligations or liability for additions or modifications to this warranty unless made in writing and signed by an officer of Fire Sentry Corporation. Fire Sentry Corporation does not warrant the installation, maintenance or service of its Products. Fire Sentry... -
Page 19: Product Variations
Fault & ALARM Relays and 4-20mA (FS17X-G) Fault, ALARM, Aux Relays w/ Fireball (FS17X-G) Detector Sensitivity High Sensitivity (Standard) Low Sensitivity Detector Type - Application General Purpose Semiconductor Page 16 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved... - Page 20 Fault Normally Closed and Normally Energized (Standard) Outputs Fault, Alert & Alarm Relays with FireBusII (Standard) Detector Sensitivity High Sensitivity (Standard) Detector Type - Application Radiant Energy (Standard) Page 17 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved...
-
Page 21: Test Lamps
Some flame detector manufacturers claim that their Detectors do not need remote testing with an external Test Lamp because their Detectors test themselves. Even though Fire Sentry Corporation Detectors also test themselves, Fire Sentry Corporation, in compliance with NFPA 72 codes, has developed portable test lamps for periodical “end-to-end”... -
Page 22: Drawings
4.4.1 Outline and Dimensions Figure 4-3 Outline & Dimesional Drawing for Model FS17X Figure 4-4 Outline & Dimesional Drawing for SM17 Swivel Mount Page 19 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved... -
Page 23: Wiring And Terminal Connections
3. Fault relay contacts shown with no electrical power applied. During normal operation and with no Fault, this relay will De-Energize and the N.O. (Normally Open) contacts will close. Page 20 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012... - Page 24 De-Energize and the N.O. (Normally Open) contacts will close. EOL (End-Of-Line) device shall be installed as required and supplied by the Fire Alarm Panel. Page 21 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012...
- Page 25 3. Fault relay contacts shown with no electrical power applied. During normal operation and with no Fault, this relay will De-Energize and the N.O. (Normally Open) contacts will close. Page 22 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012...
- Page 26 De-Energize and the N.O. (Normally Open) contacts will close. EOL (End-Of-Line) device shall be installed as required and supplied by the Fire Alarm Panel. Page 23 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012...
-
Page 27: Detector Label Drawings
Orange with Fire Alert Relay Terminal B Loop-Through Black Stripe Figure 4-13 FS17X-RHA1N- 4.4.3 Detector Label Drawings Figure 4-14 Model FS17X Detector Label Page 24 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved... -
Page 28: I Ndex
Speed of Response..............2 Input Voltage Range............... 2 Start-Up ................. 7, 8, 9 Installation ................4, 7 Storage Temperature ............. 2 Introduction................1 Page 25 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved... - Page 29 Wiring ..............19, 20, 21 Verified Fire ................2 Yellow LED ............7, 10, 11, 12 VIS ..................2 Visible Band ..............1, 10 Page 26 Fire Sentry Corporation Document No. 6178-007 - Rev. F © Copyright 2012 All Rights Reserved...
Need help?
Do you have a question about the FSXP and is the answer not in the manual?
Questions and answers