Maintenance - Hausmann XPERT PNT138-R Operator's Manual

OPERATING PROCEDURES
2. Connect the tool to the air supply. Make sure the air pressure is within the 70-110
PSI limits mentioned in SPECIFICATIONS.
3. Hold the body and press tool against the work surface, allowing it to push the
safety assembly in, until the moveable plate contacts the work surface, being sure
the tool is perpendicular to the surface.
4. Gently squeeze the trigger to drive the fastener.
5. Lift the tool off the work surface.
CLEARING A JAMMED FASTENER
CAUTION:
Disconnect the tool from the air supply.
1. Depress the safe cover to release the movable magazine unit and pull the
magazine out fully.
2. Remove any remaining fasteners from the tool.
3. Use a slender, soft steel rod to push the drive blade to its uppermost position.
Remove the jammed fastener with needle nose pliers.
4. Follow instructions in LOADING THE FASTENERS to reload fasteners

MAINTENANCE

CLEAN AND INSPECT BEFORE EACH USE
CAUTION: Disconnect tool from air supply before cleaning and inspection.
Correct all problems before putting the tool back in service.

solutions to wipe exterior of tool only if necessary. De not soak tool with cleaning
solutions. Such solutions can damage internal parts.
 Inspect trigger and safety mechanism to assure system is complete and
functional: no loose or missing parts, no binding or sticking parts.
 Keep all screws tight. Loose screws can cause personal injury or damage the tool.
 If the tool is used without an in-line oiler, place 2 drops of air tool oil into the
air inlet of the tool at the beginning of each workday and after about 1 hour
of continuous use. Frequent but not excessive lubrication is required for best
performance. Oil added through the airline connection will lubricate all internal
parts. Use only air tool oil. Do not use oil with detergents or other additives.
These can cause damage through accelerated wear to the seals in the tool.
 Use a small amount of oil on all exterior moving parts and pivots.
 Dirt and water in the air supply are major causes of pneumatic tool wear. See
the section on SETUP: AIR SOURCE above for more information.

solutions sparingly and only if necessary. Do not soak parts in the solutions.
CAUTION: Such solutions may damage O-rings and other parts.
22
PNT138-R
flammable
!
!
!