N'oveen X Series Use Instructions page 14

flash for 3 seconds to exit humidity setting function. After you set the expected
humidity, the machine will keep the memory and confirm after 5 seconds. 5
seconds later, LED display shows the current humidity. Touch again, it shows the
expected humidity setting. If the expected humidity is less than the current
humidity, the machine will be in sleeping state. But if the expected humidity is
higher than the current humidity, the humidify function will work. Long-press the
symbol
10. Timer setting: There are 12 timer setting: 1,2,3,4,5,6,7,8,9,10,11,12 hours. Touch
the symbol TIMER
till "Co" display on the LED, timer setting is cancelled. The timer shows the rest
operation time and decreases by 1 hours, i.e., if the timer is set at 12 hours, LED
display shows 11 after one hour. To know what time have been set, just to touch
TIMER symbol. Touch again, to set timer again.
11. Auto Shut-Off: Once the water in the basin is too little to keep the machine working,
the machine will automatically stop working. LED shows the shape of lack of water
. Refill the water, and the machine will restart. If don't refill water within 15
minutes, the machine will automatically power off.
12. Slide the symbol MAX-MIN
output is in the first speed. You may select 7 desired levels of mist volume. The
corresponding strip symbol will appear on the display. Long-press the symbol
or , to choose AUTO mode. On the remote control, just to press symbol
select mist output level and AUTO mode in different times.
13. On the remote controller, the related symbol controls the corresponding function.
14. No matter in any working mode, when the environment humidity reaches 90%, the
machine will be in sleeping state. When the environment humidity is under 85%,
the machine will work again.
15. No matter in any working mode, if no any operation in about 15 seconds, the
display will turn dim.
Operation steps:
Take the water tank out of the unit, open the water tank cover and fill the tank with
clear water. Close the cover and put the tank onto the base unit carefully.
Put the nozzle into the socket on top of the water tank.
Connect the power supply, switch on the unit (NEVER RUN THE UNIT WHEN
THERE IS NO WATER IN WATER BASIN), the main connection lamp will on.
The unit will begin working.
*Trouble Shooting Guide
If any trouble is found in normal operation, please kindly refer to the following points:
Trouble
Power lamp off, does not
work
Power lamp on, no mist
outlet with wind
14
or , to cancel auto humidity, but enter to AUTO mode.
, the LED display will show the desired setting timer. Touch
Possible reasons
No power supply
No water in water tank
Security switch is too
loose
, AUTO mode is cancelled and the mist
Solution
Connect power supply,
switch on
Fill water into water tank
Tighten the switch
to