Safety Instructions; Intented Use; Installation - Tecomec GEOline 8406024 Instruction Manual

WARNING
Read the instructions in this manual carefully. Tecomec S.p.a. is not responsible for
problems generated by negligence of users, by no respect of the instructions written on
this manual and for damages caused by careless usage.

SAFETY INSTRUCTIONS

Comply with the specified power supply voltage (12V
Never expose the equipment to jets of water.
Never use solvents or petroleum spirit for cleaning the outside parts of the container.
In case of electric arc welding, make sure that the power supply to the switch box is disconnected; if
necessary disconnect the tractor battery wires.
Use only original Tecomec/Geoline

INTENTED USE

This equipment is projected for installations on agricoltural spraying machines.
NOTA:all instructions and technical features given here below refer to products that Tecomec S.p.a. is
distributing at the time when this manual has been printed. To follow the standard product evelopment,
Tecomec S.p.a. reserves the right to modify and update this manual at any time and without notice.
USAGE AND STORAGE OF THE INSTRUCTION MANUAL
Reproduction of any part of this publication without the authorisation of the manufacturer (Tecomec S.p.A.)
is forbidden.
The instruction manual forms an integral part of the control panel and must be kept in a safe place which
enables it to be consulted promptly whenever needed.
This manual also becomes an integral part of the documentation of the equipment on which the control
panel is installed.
TECHNICAL FEATURES AND PERFORMANCE
Description
Power supply voltage
Oparating temperature

INSTALLATION

Switch box
Fix the box close to the driving seat, in a clearly visible but protected position, using the bracket pro-
vided. provided. The switch box must be easy to reach by the operator and has not to restrict the view
from the driving seat.
Fig.3-5 Connect the extention cable Ci (if used) with the control panel (using the Pi socket) and the
end cable Cf.
Fix the wiring so that it cannot come into contact with moving parts.
Connecting the valves
Fit the gaskets on the connectors which connect the valves to the end cable Cf.
Fix all connectors to the relevant valves, following instructions given on picture 3, and as ap-
Fig.3
propriate to the type of switch box:
gulator valve
P Re
G Main control valve
1 Electric section valve 1
4
P00801034_R00.indd 4
±10%).
parts or accessories.
Data
12V ±10%
+5°C ÷ +60°C
2 Electric section valve 2
Electric section valve 3
3
4 Electric section valve 4
Use & Instruction Manual
ENG
23/04/2007 10.02.34