Page 1
ISOBUS ECU1224 SPRAYER Connect your sprayer to Any ISOBUS tractor ! Quick reference ECU Manufacturer : Tecomec Srl Hardware ID: 00284 Software version . ECU-1224 ISOBUS 2.5.0# P00801580 ECU 1224 ISOBUS SPRAYER: Quick Reference Rev 0...
Page 2
Intended USE Congratulations Dear User, You have chosen a product by Tecomec, a leading company in the development and production of electronic systems for agriculture. This manual provides information about operating and maintaining. For your safety and the safety of the people working with this equipment, is very important that you read the manual carefully before using this system.
Page 3
CONFORMANCE Intended USE INTENDED USE ISOBUS ECU 1224 is high performance electronic control unit for liquid distribution, specially designed to work on agricultural machinery for spraying. The accurate control of the sprayer parameters increases the effectiveness and efficiency of the treatments, reducing the waste of chemicals.
Page 4
ECU1224. WARNING: Disconnect power supply ECU before reparations, or welding procedure on the vehicle. If it is not the case, Tecomec s.r.l is not responsible for damages to the ECU. WARNING: For a correct functioning, please make sure that the battery voltage is higher than 10, 5 Volt.
Page 5
CONFORMANCE Intended USE for safe operation of this equipment, preventing and repairing faulty parts and calibration. 5/24 P00801580 ECU 1224 ISOBUS SPRAYER: Quick Reference Rev 2.
THREE POINT LINKAGE Intended USE Figure 15 Dimension Configuration Figure 16 Three point linkage 14/24 P00801580 ECU 1224 ISOBUS SPRAYER: Quick Reference Rev 2.
Page 18
This product has been designed and manufactured using the most modern techniques. The manufacturer guarantees the products for 24 months from the date of purchase. Tecomec S.r.l. guarantees that ISOBUS ECU 1224 SPRAYER labeled products are covered against manufacturing defects during the following periods. Warranty periods •...
Page 19
Sensor:Flowmeter Intended USE The manufacturer excludes consumables and parts subject to normal wear and tear. The guarantee excludes intervention for updating and improvement of product. The warranty does not cover the tuning maintenance interventions which should occur during the period of guarantee. Any damage caused during transport must be reported immediately to the carrier or warranty will be void.
Page 20
The serial number must appear on the sales invoice to the final customer. • Repair and maintenance must be carried out only by Agres, Tecomec s.r.l. or authorized centers As indicated in the Returning goods topic, the documentation must be correct for the equipment analysis to begin. 20/24...