Advertisement
Replacement soldering iron：
Replacement heater
Replacement hand piece
Replacement tips:
Application
1. Suitable for desoldering multiple components.
2. Ideal for heating shrink, viscidity removal, lacquer removal, preheating and more.
3. Electronic maintenance and device welding operation.
Operation instruction
1. Put the rework station ready and place handle on the holder.
2. Connect the power cord to the power receptacle on the back panel of the station.
3. Set the blast nozzle (large caliber nozzle preferred).
4. Switch the power on, the screen displays last set value then display "SLP", it represents standby
mode.(Available in microcomputer with digital LED)
5. Press "▲"or "▼"button as to set up the temperature.
6. Adjust the airflow knob to set up the required air volume.
7. Hold the handle, the equipment begins to heat. Adjust the knob of airflow in order to set proper air
volume, operate normally when temperature is stable.
8. Put the handle back on the holder after work, the SMD station switched from heating mode to
cooling - off mode automatically. When the temperature is lower than 100℃, the station switch to
standby mode.
9. Switch the power off and unplug the power cord if there has no operation for a long time.
Attention
Please set up the temperature as lower as possible in high airflow volume as to prolong heating
element service life and better IC chips protection.
Setting up temperature
1. In the power on state, press "set" key to select the conversion between air temperature and
soldering iron temperature.
2. Press "▲"or "▼"button to set up temperature, the screen displays the setting temperature.
3. Press "▲" once the temperature degree increase 1℃, and the screen displays the setting
temperature. Press "▼" once the temperature degree decrease 1℃, and the screen displays the
setting temperature. When press the "▲"or "▼" button continuously, the temperature will increase
9SS-900N-HT
9SS-900N-SI
1
Advertisement
