Advertisement
3.
temperature is "H" or "HH", it means
temperature has been calibrated and
increased before.
4.
temperature is "L" or "L L", it means
temperature has been calibrated and
decreased before.
5.
temperature is "HHH", it means temperature
has been calibrated to max. temperature,
which can not be increased but only
decreased.
6.
"LLL", it means temperature has calibrated to
minimum temperature, which can not be
decreased but only increased..
Fahrenheit and Centigrade Selection
Press the "SET" button and turn on the power switch to power on the
station as Fig.11, and switch the temperature display from ℃ to ℉ by
pressing the UP ▲ or Down button ▼. After selection, press "SET"
button to confirm and back to the main menu
Fig.11
Reset
Press the UP ▲ and DOWN ▼ button in the same time, rework station
will be back to the initial setting; after one second, LCD screen be back to
the standby mode(Fig.12).
Fig.12
CAUTION: Choose reset mode will modify all the parameter to the
initial setting, please do it carefully.
Auto Sleep
When hot air gun put on the holder, the temperature of hot air gun will
start to decrease (Fig.13), and the display will show " SLP" to indicate hot
air gun is in sleep mode now. When the temperature is lower than 100℃,
the station will display as Fig.3. It will awake the rework station when hot
air gun lift from the holder.
Fig.13
Auto Cool-Off
After the rework station is turned off, the auto cool-off process leaves the
blower on until the heating element cool down to
rework station will shut off automatically.
When the status display under
When the status display under
When the status display under
The status display under temperature is
100℃(Fig 14.),
Fig.14
CAUTION: Do not unplug the power plug when the auto cool off
process is work on.
Do not touch the pin of plug to prevent electrical shock for human body.
How to use suction pen(SS-956)
1)
Choose a proper suction cup according to the weight (less than 100g)
and size of object. Install the cap with the suction pen. (Fig. 15)
2)
Put the suction cup horizontally with the surface of the adsorbed
object. Cover the hole on the suction pen, and the object will be absorbed.
(Fig. 16)
3)
Move out the absorbed object, and then open the hole on the suction
pen to release the object.
4)
If need to use suction pen only,(Fig. 17) put the hot air gun on holder,
and rework station will be in the auto sleep mode. Press the UP ▲ or
Down button ▼ to adjust air speed(air speed range from 20~100)
For further more detailed information, please visit Pro'skit website
http://www.prokits.com.tw or scan the QR code
©2020 Prokit's Industries Co., LTD. All rights reserved 2020001(C)
then
Fig.15
Fig.16
(Fig. 17)
PROKIT'S INDUSTRIES CO., LTD
http://www.prokits.com.tw
Email: pk@mail.prokits.com.tw
Advertisement
