Advertisement
Installation steps
Step 1 Start by taking your phone up to the roof or other location outside to find where the signal
is strongest.
Step 2 Temporarily mount the Outdoor (outside) antenna in that location. You may need to
adjust and move the antenna later.
Step 3 Run coaxial cable into the building to a convenient loaction (attic, etc.) where you can
also get standard power for the Signal Repeater.
Step 4 Place the Signal Repeater in that location and connect the coaxial cable to the Outdoor
Side of the Signal Repeater and the Outdoor antenna.
Step 5 Mount your Indoor (inside) antenna in a productive location. You may need to adjust or
move the antenna later. More notes on Indoor antennas and patterns here.
Step 6 Connect coaxial cable between the Indoor antenna and the Signal Repeater output port.
Step 7 Power up the system and check for signal inside the building. If needed, tune system by
moving and or pointing the Outdoor and Indoor antennas until they get the most signal possible.
Step 8 Secure all antennas and cables, securely mount the Signal repeater and clean up the
installation.
Of course there are still a few more things to consider but in general, this is the basic
procedure. For more information, please contact us.
Advertisement
