Application State; Setting The Application State; Configuring The Scan2Crm For Act; Scanning Cards - CSSN ScanShell 800N User Manual

Using Scan2CRM for Act!
The scanner must be calibrated prior to
scanning business cards, please refer to
Calibrating the scanner, page 12 for
instructions. Once the scanner is calibrated
make sure the configuration window is closed to
begin scanning business cards.

APPLICATION STATE

When the application loads, its state is set to
Enabled by default.

Setting the application state

Press on the state button to toggle between
Enabled and Disabled states.
If the application is enabled (green button),
pressing on the state button will disable the
application and the button will be grayed out.
If an error occurred while the application
was loaded, the state will be set to Disabled.
You can try to enable the application by
pressing on the state button. If this does not
help, check if the scanner is properly
connected and try again.

Configuring the Scan2CRM for Act!

See Configuration, page 9.

SCANNING CARDS

Place the business card in the scanner with
the text face down.
If the card is a horizontal card, place the
card into the scanner horizontally and if the
card is vertical, place the card into the
scanner vertically. (If you do not do this, the
software will automatically rotate the card.)
Scan2CRM for Act! User Guide, version 3.5
Application State
7