Installation Instructions - Zephyr AK1710 Use, Care And Installation Manual

ZEPHYRONLINE.COM
The backsplash should be installed before the hood is installed.
1. Position the lower section of backsplash on the wall. Center it side to side and mark the holes.
Remove the lower section from the wall.
2. If installing onto drywall only and not onto studs, insert wall anchors (EZ anchors are
recommended) into the marked holes. If installing onto studs, attach screws without EZ anchors.
3. Attach lower section of backsplash to the wall with screws provided.
4. Position upper section of backsplash on the wall. The position of the upper section should be at
least 1" above the bottom of the hood so the recessed screws are covered. Center it side to side
and mark the holes. Remove the upper section from the wall and install wall anchors into marked
holes.
5. Peel off the double-sided tape. Attach upper section to wall with screws provided.
6. Use the double-sided tape to adhere both the upper and lower sections together.
Stainless Steel Backsplash Use, Care, and Installation Guide

Installation Instructions

WARNING
7