Functioning; Operation; Setting Up The Product; Replacing The Rechargeable Battery - LIVARNO 354384 2010 Assembly, Operating And Safety Instructions

Risk of damage of the product
Only use the specified type of battery /
rechargeable battery!
Insert batteries / rechargeable batteries accord-
ing to polarity marks (+) and (-) on the battery /
rechargeable battery and the product.
Use a dry lint-free cloth or cotton swab to
clean the contacts on the battery / rechargea-
ble battery and in the battery compartment be-
fore inserting!
Remove exhausted batteries / rechargeable
batteries from the product immediately.

Functioning

The solar cell installed in the product converts sun-
light into electrical energy and stores it in one re-
chargeable battery. Switch on the product with the
ON / OFF button . The product will automati-
15
cally light on as it begins to get dark. The in-built
light-emitting diodes are a very long-life and ener-
gy-saving light source. The light duration depends
on the amount of sunlight, the angle of light on the
solar cell and the temperature (the battery capacity
is temperature-dependent). A vertical angle of light
at temperatures above the freezing point is ideal.
The battery does not achieve maximum capacity
until after several charge and discharge cycles.
In summer a completely drained rechargeable bat-
tery takes about 2 to 4 days to fully recharge in
constant sunlight.

Operation

1. Take out the solar panel compartment.
2. Switch the ON / OFF button
the product will automatically switch on at dusk
(see Fig. C).
3. Put the solar panel compartment back into dec-
oration figure . Insert the tail
1
to the main body (see Fig. B).
7
8 GB
Model C:
Model A and B:
The battery should be replaced every 12 months to
ensure optimum performance.
1. Take out the solar panel compartment. If neces-
to ON position,
15
and stand
2
2. Exchange the old rechargeable battery

Setting up the product

(see Fig. B)
Insert the stand to the Decoration figure
7
then use the secure screw
ground spike over the top of the stand
6
anchor ground spike
6
Insert the tail to the decoration figure
2
Insert the tail to the connector
2
hexagon screws by hexagon key
5
it. After that, insert the connector
oration figure upward or downward and fix
1
it with hexagon screw
In order to achieve the best result, set the prod-
uct up in a place where the solar panel
get direct sunlight for as long as possible.
Make sure that the solar panel
enced by any other source of light such as
yard or street lighting as otherwise the light will
not come on in twilight.
The light automatically switches on in twilight
conditions and off again when normal outdoor
lighting conditions return.
Replacing the rechargeable
battery (see Fig. C)
sary, take a tool to help. Switch the ON / OFF
button to OFF position to switch off the
15
product. Loosen the fastening screws
using a small cross head screwdriver and then
lever out the battery compartment cover
with the help of a slot screwdriver.
a new one. Take care to the correct polarity,
when inserting the new rechargeable battery.
The polarity is indicated in the battery compart-
ment . The new rechargeable battery has to
13
1
to fix it. Place the
8
then
7
to the ground to fix it.
.
1
, then use
3
to fix
4
to the dec-
3
too.
5
will
9
is not influ-
9
by
10
11
to
14