Door Closing; Base Grille - Whirlpool W11176204A Use & Care Manual

Door Closing

Your Beverage Center has two leveling legs. If your Beverage
Center seems unsteady or you want the door to close more
easily, adjust the Beverage Center's tilt using the instructions
below.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
beverage center.
Failure to do so can result in back or other injury.
2. Move the Beverage Center into its final location.
3. Turn the leveling legs to the right to lower the Beverage
Center or turn the leveling legs to the left to raise it. It may
take several turns of the leveling legs to adjust the tilt of the
Beverage Center.
NOTE: Having someone push against the top of the
Beverage Center takes some weight off the leveling legs.
This makes it easier to adjust the leveling legs.
4. Open the door again to make sure that it closes as easily as
you like. If not, tilt the Beverage Center slightly more to the
rear by turning both front leveling screws to the left. It may
take several more turns, and you should turn both leveling
legs the same amount.
6

Base Grille

Tools Needed: Phillips screwdriver
Remove the Base Grille
1. Open the Beverage Center door.
2. Using the screwdriver, remove the two screws.
3. Remove the base grille.
Replace the Base Grille
1. Open the Beverage Center door.
2. Position the base grille so that screw holes align into place.
Replace the two screws. Tighten the screws.