Table of Contents
Advertisement
Available languages
Available languages
Location Requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from beverage center.
Failure to do so can result in death, explosion, or fire.
To ensure proper ventilation for your Beverage Center, allow
for a 1/4" (6.35 mm) space on each side and at the top. When
installing your Beverage Center next to a fixed wall, leave 21/2"
(6.35 cm) minimum clearance on the hinge side to allow for the
door to swing open.
NOTE: It is recommended that you do not install the Beverage
Center near an oven, radiator, or other heat source. Do not
install in a location where the temperature will fall below 55°F
(13°C). For best performance, do not block the base grille.
Opening Dimensions
Height dimensions are shown with the leveling legs
■
extended to the minimum height.
NOTE: When leveling legs are fully extended, add 5/8" (1.6
cm) to the height dimensions.
If the floor of the opening is not level with the kitchen floor,
■
shim the opening to make it level with the kitchen floor.
14 ¾"
(37.5 cm)
1/2"
(1.3 cm)
Critical dimensions:
A. 14.3/4" (37.5 cm) utility opening
B. 24" (60.96 cm) minimum opening width
4
INSTALLATION INSTRUCTIONS
1/4" (6.35 mm)
2 ½" (6.35 cm)
34 ³/ " (87.3 cm) min.
35" (88.9 cm) max.
A
24"
(60.96 cm) min.
B
24" (60.96 cm) min.
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your Beverage Center into its final location,
it is important to make sure you have the proper electrical
connection.
Recommended grounding method
A 115 Volt, 60 Hz., AC only, 15A or 20A fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your Beverage Center be provided. Use
an outlet that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, or cleaning,
unplug Beverage Center or disconnect power.
Unpack the Beverage Center
WARNING
Excessive Weight Hazard
Use two or more people to move and install
beverage center.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning
■
on the Beverage Center. Rub a small amount of liquid dish
soap over the adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing alcohol, flammable
■
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your Beverage Center.
For more information, see "Beverage Center Safety."
Dispose of/recycle all packaging materials.
■
When Moving Your Beverage Center
Your Beverage Center is heavy. When moving the Beverage
Center for cleaning or service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always pull
the Beverage Center straight out when moving it. Do not
wiggle or "walk" the Beverage Center when trying to move it,
as floor damage could occur. Having someone push against
the front top of the Beverage Center takes some weight off
the front leveling legs. This makes it easier to push the unit
on the rear rollers.
Advertisement
Table of Contents
