Advertisement
Quick Links
Advertisement
Summary of Contents for FibroPool FibroSlide
- Page 1 FibroSlide Installation and User Manual...
- Page 2 FibroSlide Assembly Instructions: • BE SURE TO LAY A CLEAN BLANKET, BUBBLE WRAP OR CARDBOARD • BENEATH THE FIBERGLASS COMPONENTS TO AVOID SCRATCHING. INVENTORY ALL PARTS, COMPONENTS, BOLTS, NUTS BEFORE ASSEMBLY. • BE SURE THAT YOU HAVE ALL NECESSARY TOOLS ON HAND BEFORE •...
- Page 3 swim in deep water. 8. Weight limit for this slide is 200 pounds, no slider weighing more than 200 pounds may use this slide. 9. The surface of the slide is very slippery when wet; USE CAUTION when entering the slide and when transitioning from standing to sitting.
- Page 4 23. Do not use this slide if physically impaired or handicapped without your doctor’s permission. 24. Do not use this slide with a history of heart conditions, seizures, back problems, fainting or fear of heights. 25. Do NOT use this slide if you are pregnant. 26.
- Page 5 Contents of package: Lower slide Section (Lower Flume) Upper Slide Section (Upper Flume) Ladder pipes(2) Ladder Rungs(6) Handrail(2) Legs(4) Handrail to Ladder Bolts(4) Handrail Top Bolts (2)
- Page 6 Handrail back Bolts (2) Ladder Rung Bolts(12) Leg Bolts,Top and Bottom(10) Hex Key Wrench(1) Tube, Valve, adapter, Nozzle, Clamp(2), Sealant Leg Anchors(4), Ladder Anchors(2) Flume Bolts for connecting 2 pieces of the slide flume Safety Stickers and User Manual...
- Page 7 Assembly Instructions: Choose a clear area, lay out the cardboard box and the blankets as work area. • Cut open the Bubble wrap from the flat ends of the 2 pieces of flume. • Lay 2 pieces of the flume upside down ( slide part down against the blanket) •...
- Page 8 Align the holes, and insert bolts and hand tighten all of the nuts. • Once all bolts are in place; using a wrench, tighten up the bolts and nuts. Be careful not to over • tighten and crack the fiberglass. Insert slide legs(4) and Ladder Legs •...
- Page 9 Line up the hand rail, then install the upper bolts(short). Hand tighten only. • Install the back bolts, through the slide body, ladder leg, into the handrail. • Install the remaining 4 bolts to connect the handrails to the legs. •...
- Page 10 Once all screws are in position and hand tight, go ahead and tighten them using a wrench. • Insert upper leg bolts and tighten • Insert Leg Anchors and tighten. • 2 Front and Left leg anchor (3) Middle Right anchor (1) Ladder anchor(2) Note: 3 anchors are same, 2 for the front, 1 for the left side of the slide.
- Page 11 Insert hose to sprayer and tighten the clamp. • Glue in the adapter into the valve. • Attach the water hose to the adapter, feeding through the middle hole on the flume joint and • install the clamp.
- Page 12 Install Safety Stickers Position the slide, as per drawings. • Drill and anchor down. • Use appropriate methods for fastening to the specific surface your slide is installed on. • Use high quality fasteners. • Be sure to tighten all anchors well. •...
- Page 15 FIBROSLIDE LIMITED FACTORY WARRANTY Fibropool Co. LLC warrants this Pool Slide, to the original owner, to be free of material and workmanship defects for a limited ONE (1) year term. Specific warranty terms are listed below. This warranty will begin on the day of the purchase, verified by the homeowner’s proof of purchase documents.