Related Manuals for FibroPool FIBROSLIDE
Summary of Contents for FibroPool FIBROSLIDE
- Page 2 Before Assembly Be sure to lay a clean blanket, bubble wrap or cardboard beneath the fiberglass components to avoid damage. Check that all parts, hardware, and necessary tools are present. Find someone that can assist you. Assembly will require two people. 1.
-
Page 3: Contents Of Package
CONTENTS OF PACKAGE: Upper Slide Section (Upper Flume) Lower slide section (Lower Flume) “A” ”B” Ladder Pipes (2pcs) Handrail (2pcs) Ladder Rungs (6pcs) Slanted Ladder “N” Anchors (2pcs) Legs (4pcs) “C” 35.75” “D” 29.5” “E” 13.25” “F” 12”... - Page 4 “W” Warped Outside foot (1pc) “M” Leg Anchors (3pcs) Handrail Through-Fiberglass Bolts with Plastic Cushions (2pcs) “I” 2 1/2” Handrail Top Bolts with Plastic Cushions (2pcs) “H” 1 1/8” Leg Bolts, Top and Ladder “K” Bottom (10pcs) “J” Ladder Rung Bolt (12pcs) Tap Screws for anchors “Q”...
- Page 5 Flume Bolts (8pcs) “L” Tube, Clamp “AA” (2pcs), Sealant, Sprayer “R”, Adapter “Z” , Valve “BB” Safety Stickers and User Manual “X” TOOLS WE PROVIDE: Hex Key Wrench (1 each) Drill bit for Predrilling tap screws (1) 3/16” Nut Setter Tip for Self tapping 8 mm and 5mm “O”...
- Page 6 Assembly Instructions: Choose a clear area, lay out the cardboard box and blankets as a work area Cut open the bubble wrap from the flat ends of the 2 pieces of flume, but leave the wrap in place for protection. Lay 2 pieces of the flume upside down (slide part down against the blanket) Apply a continuous...
- Page 7 Stand the slide right side up Align the handrail “B” at the top, placing a plastic spacer between the rail and fiberglass to prevent scratching. Insert the upper bolts “H” with metal washer facing upward, through the fiberglass and into the handrail tube. Get the bolt started, but wait to tighten until all bolts are in place.
- Page 8 Once all screws are in position and hand tight, tighten them using a wrench. Insert upper leg bolts “K” into the receivers on the fiberglass where the vertical legs seat and tighten Bolt the 2 ladder anchors “N” into the bottom of the ladder tubes “A”...
- Page 9 Install screws “Q” Pilot drill the holes using the 10mm nut tip “DD” using the 3/16” drill bit “CC” Insert water sprayer “R” and silicone washer on top of slide. Hand tighten the retainer nut beneath the slide. Insert hose to sprayer and tighten the clamp.
- Page 10 Attach the water hose to the adapter, and feed through the middle hole on the flume joint. install the clamp. Install Safety Stickers Screw and tighten Mark and drill Drop in the anchor sleeve ”V” the anchor lag bolts “U” the concrete using drill bit “P”...
- Page 11 Position the slide as per drawings. Drill and anchor using high quality fasteners, ensuring all anchors are tightened well. Use best practices for fastening to the surface your slide is installed on. Turn on the water supply and adjust spray so pool does not lose much water. Be safe and ENJOY.