Table of Contents
Advertisement
OPERATION
To reduce the risk of fire and
WARNING
injury, do not use to pick up
flammable or combustible materials. Empty
dust box completely before use.
To reduce the risk of injury, always wear proper
eye
protection
AS/NZS 1337.1.
When working in dusty situations, wear
appropriate respiratory protection or use a
suitable dust extraction solution.
Proper Operation
1. Empty the dust box.
NOTE: For optimal use to remove debris in the
dust box, connect a hose to a vacuum and remove
debris.
2. Install and position the nozzle assembly to the
desired side.
3. Fit the HAMMERVAC™ to the tool and bit.
4. Set the drill depth.
5. Install the battery pack.
6. Pull trigger to start HAMMERVAC™.
7. Begin use according to tool manufacturer instructions.
8. Always hold the tool securely using both handles
to maintain control.
9. Stop and empty dust box:
• When suction decreases,
• When dust begins to come through the bit brush,
•
NOTE: When the HAMMERVAC™ has come to a
stop, the AUTOPULSE™ Filter Cleaning Mechanism
could become lodged. For best performance, position
the HAMMERVAC™ either horizontally or vertically
downward (pointed at the ground) during this cycle.
Empty the dust box often.
marked
to
comply
WARNING
remove the battery pack from the charger or
tool before performing any maintenance. Never
disassemble the tool, battery pack or charger.
Contact a MILWAUKEE
with
repairs.
Do not use tool without dust box and HEPA filter
in place.
Keep filter clean. Empty debris by holding away
from the user's face and tapping dust box into a bin,
or other reasonable container. For best cleaning
results, connect a vacuum hose with dust extraction
adapter (Cat . No. 49901959) to the dust box port
and suction out debris. Pull the HEPA filter away
from the dust box and tap clean. Do not clean with
water or compressed air. After about 1500 holes or
loss of suction, discard and replace HEPA filter
(Cat. No. 49902306).
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage
of parts, or any other condition that may affect the
tool operation. Return the tool, battery pack, and
charger to a MILWAUKEE
After six months to one year, depending on use,
return the tool, battery pack and charger to a
MILWAUKEE
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work
properly, return the tool, charger and battery pack,
to a MILWAUKEE
Clean dust and debris from any vents. Keep tool
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain clean-
ing agents and solvents are harmful to plastics and
other insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household deter-
combustible solvents around tools.
For repairs, return the tool, battery pack and charger
to the nearest authorised service centre.
WARNING
may be hazardous.
For a complete listing of accessories, go online to
www.milwaukeetool.com.au
www.milwaukeetool.co.nz or contact a distributor.
6
MAINTENANCE
To reduce the risk of injury,
always unplug the charger and
service facility for ALL
®
Maintaining Filter
Maintaining Tool
service facility for repair.
®
service facility for inspection.
®
service facility for repairs.
®
Cleaning
Repairs
ACCESSORIES
Use only recommended
accessories. Others
/
Advertisement
Table of Contents
