Quanser QNET 2.0 DC Motor Quick Start Manual page 2

STEP 4
Set up the Hardware
To set up the QNET DC Motor, please read the following instructions carefully. For full details, see the QNET DC Motor
User Manual.
A
B
Place the handle on the front of the QNET
board over the bracket located on the front
of the NI ELVIS II.
D
24V 2.0A
E
PC
F
24V 2.0A
24V 2.0A
Ensure that the NI ELVIS II power switch
is in the off position.
C
Slide the PCI connector at the back of the
QNET board into the female connector on
the NI ELVIS II.
+15V
-15V
+5V
External Power
Connect the NI ELVIS II power supply
External Power
to the back panel of the NI ELVIS II.
Use the NI ELVIS II USB cable to connect
the NI ELVIS Unit to your computer.
Connect the QNET DC Motor power supply.
External Power
+15V
-15V
+5V
+15V
-15V
+5V